Whirlpool CAM2752TQ User Manual

First try the solutions suggested here or visit our website to possibly avoid the cost of a service call... 

In U.S.A. http://www.whirlpool.com/help - In Canada www.whirlpool.ca

Add an Extra Rinse to the selected cycle. 

Heavy sand, pet hair, lint, and  

detergent or bleach residues may 

require additional rinsing. 

Sand, pet hair, lint,  

etc. on load after  

washing
Load is tangling

Washer not loaded as recommended.

See “Using Your Washer” section.
Select a cycle with a slower wash action and spin speed; however, 

items will be wetter than those using a higher speed spin. See the 

“Cycle Guide” to match your load with the best cycle.
Load garments in loose heaps evenly around the basket wall.
Reduce tangling by mixing types of load items. Use the  

recommended cycle for the type of garments being washed.

Incorrect or wrong  

wash or rinse  

temperatures

Check for proper water supply.

Make sure hot and cold inlet hoses are not reversed.
Both hoses must be attached to both washer and faucet, and  

have both hot and cold water flowing to inlet valve.
Check that inlet valve screens are not clogged.
Remove any kinks in hoses.
This washer uses cooler wash and rinse water temperatures than 

your previous washer. This includes cooler hot and warm washes.

Energy saving controlled  

wash temperatures.

The high spin speeds combined with air flow during the final  

spin can cause items near the top of the load to develop dry 

spots during the final spin. This is normal. 

High speed spins extract more  

moisture than traditional top-load 

washers.  

Dry spots on load  

after cycle

Load not rinsed

Check for proper water supply.

Make sure hot and cold inlet hoses are not reversed.
Both hoses must be attached and have water flowing to the  

inlet valve.
Both hot and cold water faucets must be on.
Inlet valve screens on washer may be clogged.
Remove any kinks in the inlet hose.

Using too much detergent.

The suds from too much detergent can keep washer from  

operating correctly. Always measure detergent and follow  

detergent directions based on load size and soil level. 

Washer not loaded as recommended.

The washer is less efficient at rinsing when load is tightly packed.
Load garments in loose heaps evenly around the basket wall.

Load with dry items only.
Use cycle designed for the fabrics being washed.
Add only 1 or 2 additional garments after washer has started.

Using too low a load size/water level 

selection.

Choose a load size (water level) that matches the load being 

washed.

Use a cycle with a low spin speed.

Cycles with lower spin speeds remove less water than cycles  

with high spin speeds. Use the recommended cycle/speed spin 

for your garment. To remove extra water in the load, select Drain 

& Spin. Load may need to be rearranged to allow even  

distribution of the load in the basket.

Small items may have been caught in pump or between basket 

and tub, which can slow draining.

Empty pockets and use garment bags 

for small items.

Washer not draining/ 

spinning, loads  

are still wet, or spin 

light remains on  

(indicating that the 

washer was unable  

to pump out water 

within 10 minutes)

The washer may be tightly packed or 

unbalanced.

Tightly packed or unbalanced loads may not allow the washer  

to spin correctly, leaving the load wetter than normal. Evenly  

arrange the wet load for balanced spinning. Select the Drain & 

Spin cycle to remove excess water. See “Using Your Washer” for 

loading recommendations. 

Check plumbing for correct drain hose 

installation. Drain hose extends into 

standpipe farther than 4.5" (114 mm). 

Check drain hose for proper installation. Use drain hose form  

and securely attach to drainpipe or tub. Do not tape over drain 

opening. Lower drain hose if the end is higher than 96" (2.4 m) 

above the floor. Remove any clogs from drain hose.

Too much detergent causing suds to 

slow or stop draining and spinning.

Always measure and follow detergent directions for your  

load. To remove extra suds, select Rinse & Spin. Do not  

add detergent.