Whirlpool CAM2752TQ User Manual

Operate your washer only when you are home. If moving, or 

not using your washer for a period of time, follow these steps:

1.  Unplug or disconnect power to washer.
2.  Turn off water supply to washer, to avoid flooding due  

to water pressure surge.

IMPORTANT: To avoid damage, install and store washer  

where it will not freeze. Because some water may stay in  

hoses, freezing can damage washer. If storing or moving  

during freezing weather, winterize your washer.
To winterize washer:

1.  Shut off both water faucets; disconnect and drain water     

inlet hoses.

2.  Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run 

washer on RINSE & SPIN cycle for about 30 seconds  

to mix antifreeze and remaining water.

3.  Unplug washer or disconnect power.

Performing at its Best
1. Always follow the detergent manufacturer’s instructions 

regarding the amount of detergent to use. Never use more 

than the recommended amount because that may increase 

the rate at which detergent and soil residue accumulate 

inside your washer, which in turn may result in undesirable 

odor.

2. Use warm and hot wash water settings sometimes (not 

exclusively cold water washes), because they do a better 

job of controlling the rate at which soils and detergent 

accumulate.

3. Always leave the washer lid open between uses to help dry 

out the washer and prevent the buildup of odor-causing 

residue.

Cleaning Your Top Loading Washer
Read these instructions completely before beginning the 

routine cleaning processes recommended below. This Washer 

Maintenance Procedure should be performed, at a minimum, 

once per month or every 30 wash cycles, whichever occurs 

sooner, to control the rate at which soils and detergent may 

otherwise accumulate in your washer.
Cleaning the Inside of the Washer
To keep your washer odor-free, follow the usage instructions 

provided above, and use this recommended monthly cleaning 

procedure:
Recommended Cycle for Cleaning the Washer
Refer to the “Cycle Guide” for the optimal cycle for cleaning 

the inside of the washer. Use this cycle with affresh

®

 Washer 

Cleaner or liquid chlorine bleach as described below.
Begin procedure
1. affesh

®

 Washer Cleaner Cycle Procedure (Recommended    

  for Best Performance):

a. Open the washer lid and remove any clothing or items.
b. Place an affesh

®

 Washer Cleaner tablet in the bottom of 

the washer basket.

c. Do not place an affresh

®

 Washer Cleaner tablet in the 

detergent dispenser.

d. Do not add any detergent or other chemical to the washer 

when following this procedure.

e. Close the washer lid.
f. Select the cycle recommended for cleaning the inside of 

the washer.

g. Press the START/Pause/Unlock button to start the cycle.

NOTE: For best results, do not interrupt cycle. If cycle must 

be interrupted, press START/Pause/Unlock once or twice 

(depending on model). After the cycle has stopped, run a 

RINSE & SPIN cycle to rinse cleaner from washer.
2. Chlorine Bleach Procedure (Alternative):

a. Open the washer lid and remove any clothing or items.
b. Add 1 cup (236 mL) of liquid chlorine bleach to the bleach 

compartment.

NOTE: Use of more liquid chlorine bleach than is 

recommended above could cause washer damage over 

time.
c. Close the washer lid.
d. Do not add any detergent or other chemical to the washer 

when following this procedure.

e. Select the cycle recommended for cleaning the inside of 

the washer.

f.  Press the START/Pause/Unlock button to start the cycle.
NOTE: For best results, do not interrupt cycle. If cycle must 

be interrupted, press START/Pause/Unlock once or twice 

(depending on model). After the cycle has stopped, run a 

RINSE & SPIN cycle to rinse cleaner from washer.

Cleaning the Dispensers
After a period of using your washer, you may find some residue 

buildup in the washer’s dispensers. To remove residue from 

the dispensers, wipe them with a damp cloth and towel dry. 

Do not attempt to remove the dispensers or trim for cleaning. 

The dispensers and trim are not removable. If your model has 

a dispenser drawer, however, remove the drawer and clean 

it before or after you run the Clean Washer cycle. Use an all-

purpose surface cleaner, if needed.
Cleaning the Outside of the Washer
Use a soft, damp cloth or sponge to wipe away any spills. Use 

only mild soaps or cleaners when cleaning external washer 

surfaces.
IMPORTANT: To avoid damaging the washer’s finish, do not 

use abrasive products.

1.  Shut off both water faucets. Disconnect and drain water     

inlet hoses.

2.  If washer will be moved during freezing weather, follow     

Winter Storage Care directions before moving.

3.  Disconnect drain from drain system and drain any  

remaining water into a pan or bucket. Disconnect drain 

hose from back of washer.

4.  Unplug power cord.
5.  Place inlet hoses and drain hose inside washer basket.
6.  Drape power cord over edge and into washer basket.
7.  Place packing tray from original shipping materials back 

inside washer. If you do not have packing tray, place heavy 

blankets or towels into basket opening. Close lid and place 

tape over lid and down front of washer. Keep lid taped until 

washer is placed in new location.