Westinghouse 19 SEER, 10 HSPF iQ Drive Technical Manual
TECHNICAL
SPECIFICATIONS
SPECIFICATIONS
•
iQ Drive: Inverter driven Samsung rotary compressor
provides five capacities in modulating operation from a two
stage thermostat.
•
Interface control board: Two digit LED provides system
operation, status and diagnostic troubleshooting information.
- Utilizes a NOrDyNE: patented capacity control algorithm
to select the optimum system capacity level.
- System Protection: Internal controls monitor system
operation to protect the inverter drive and compressor.
- Cooling operating temperature range: 50 °F to 125 °F.
- Locks out heat pump heating: below 0 °F.
- Adaptive demand defrost: Provides additional energy
savings in heating by defrosting only when necessary.
- Five Minute restart Time Delay: When the unit shuts
down, a delay keeps the unit from restarting,
eliminating the highest cause for compressor failure.
• Suction Accumulator: Protection from liquid flood back
and future compressor failures.
• R-410A Refrigerant: Environmentally friendly non-ozone
depleting refrigerant.
• Compressor and Component Access: Designed to make
servicing easier for the contractor, hinge access panels are
provided to all controls and the compressor.
• High Efficiency with the low Sound Levels: Up to 19
SEER with sound ratings of 59-73 depending upon operating
conditions.
• Compressor Sound Blanket: Engineered to significantly
reduce unwanted compressor noise.
• Variable Speed Condenser Motor and Swept-Wing Fan
Blade: A heavy duty brushless DC motor for long lasting
reliability and engineered to provide quiet operation. Requires
no maintenance and is completely protected from rain and
snow.
• Common Suction Service Port: This port allows the
contractor to read the suction pressure in all modes of
operation without removing any panels, saving time and
increasing serviceability.
• Discharge muffler: Reduces compressor noise and
vibration.
• High Pressure Switch: Protects against abnormally high
system pressures. Auto-reset feature prevents nuisance
service visits.
• Low Pressure Switch: Protects against loss of system
refrigerant charge.
• Liquid Line Filter Drier: Included with unit, field installed.
• Copper Tube / Aluminum Fin Coils: outdoor coils are
designed to optimize heat transfer, and increase durability
and reliability.
• Louvered Condenser Guard: Durable metal guard protects
the coil from yard hazards and extreme weather.
• Composite Base Pan: Absorbs sound and is corrosion
resistant. Composite pan is also stronger and lighter than
steel.
• Designed using galvanized steel: with a polyester urethane
coat finish. The 950 hour salt spray finish resists corrosion
50% better than comparable units.
• One Piece Top/Orifice: Designed for maximum airflow and
quiet operation.
• Removable Top Grille Assembly: Allows ease of service
from the top without disconnecting fan motor leads.
FT4BG Series
R-410A, Ultra High Efficiency
Heat Pump,
Up to 19 SEER Residential System
2-5 Ton Capacities
Heat Pump,
Up to 19 SEER Residential System
2-5 Ton Capacities
The iQ Drive
®
heat pump system features modulating
compressor technology and variable speed indoor and
outdoor fan motors. This system is controlled from a two
stage cooling and heating heat pump thermostat. The
system has the capability of adding up to 18% of additional
cooling/heating above the rated capacity. The B6VMAX
air handler has de-humidification capabilities from the
thermostat or duct mounted humidistat.
outdoor fan motors. This system is controlled from a two
stage cooling and heating heat pump thermostat. The
system has the capability of adding up to 18% of additional
cooling/heating above the rated capacity. The B6VMAX
air handler has de-humidification capabilities from the
thermostat or duct mounted humidistat.
FEATURES and BENEFITS
– This product offers a 10-year all-parts warranty.
– This product offers a 10 year Quality Pledge to replace
– This product offers a 10 year Quality Pledge to replace
the entire unit, if the unit’s major component (heat
exchanger or compressor) fails within the first 10 years
of operation, to the original owner. All split system
products must be installed with a matched indoor air
handler or indoor coil to qualify.
exchanger or compressor) fails within the first 10 years
of operation, to the original owner. All split system
products must be installed with a matched indoor air
handler or indoor coil to qualify.
– Consumer product registration required for both 10
year All Parts Warranty and Quality Pledge within a
limited period of time after the installation. See current
warranty document or visit our consumer web for
warranty details.
limited period of time after the installation. See current
warranty document or visit our consumer web for
warranty details.
WARRANTY