Weed Eater WET2242STA Owner's Manual

The transaxle should be in neutral when the gear shift 
lever is in neutral (N) (lock gate) position. The adjustment 
is preset at the factory; however, if adjustment is needed, 
proceed as follows:
•      Make sure transaxle is in neutral (N).
NOTE: When the tractor rear wheels move freely, the 

transaxle is in neutral.

•     Loosen adjustment bolt in front of the right rear 

wheel.

•     Position the gear shift lever in the neutral (N) posi-

tion.

•      Tighten adjustment bolt securely.
NOTE:  If additional clearance is needed to get to ad just ment 
bolt, move mower deck height to the lowest position.

If steering wheel crossbars are not horizontal (left to right) 
when wheels are positioned straight forward, remove steer-
 ing wheel and reassemble per instructions in the Assembly 
section of this manual.

The front wheel toe-in and camber are not adjustable on 
your tractor.  If damage has occurred to affect the front 
wheel toe-in or camber, contact your nearest authorized 
service center/department.

•      Block up axle securely.
•         Remove axle cover, retaining ring and washers to allow 

wheel removal (rear wheel contains a square key - Do 
not lose).

•      Repair tire and reassemble.
•      On rear wheels only:  align grooves in rear wheel hub 

and axle.  Insert square key.

•      Replace washers and snap retaining ring securely in 

axle groove.

•      Replace axle cover.

NOTE: To seal tire punctures and prevent fl at tires due to 
slow leaks, tire sealant may be purchased from your local 
parts dealer. Tire sealant also prevents tire dry rot and 
corrosion.