Marantz SR5300 User Manual

24

This mode bypasses all surround processing.
Stereo program sources the left and right channels play normally
when PCM-audio or analog stereo is input.
With Dolby Digital and DTS sources, the 5.1 multi-channels are
converted to two channel stereo. 96 kHz source material can be
playback in stereo mode.

In the source direct mode, the tone control circuit and bass
management configuration are bypassed for full range frequency
response and the purist audio reproduction.
96 kHz PCM source material can be play back in this mode.

• Internal speaker size is setup to front L/R = Large, Center =

Large, Surround L/R = Large and Subwoofer = yes
automatically. Tone controls and additional processing are also
defeated.

• When you use this mode with certain DVD and CD players,

performing operations such as “Skip” or “Stop” may
momentarily interrupt the output.

NOTE for DTS signal
* Connected DVD-player, laser-disc player or CD-player needs to

support DTS-digital output. You may not be able to play some DTS
source signals from certain CD players and LD players even if you
connect the player to the SR5300 digitally. This is because the
digital signal has been processed (such as the output level,
sampling frequency, or frequency response) and the SR5300
cannot recognize the signal as DTS data.

* Depending on the player used, DTS play may produce short noise.

This is not a malfunction. In such cases, select the surround mode
the “DTS” or “DTS-ES”.

* If DTS cinema, DTS music or DTS-ES mode is selected, digital

input cannot be switched to analog input.

* When the analog input function has been selected, Surround mode

cannot be switched to DTS cinema, DTS music or DTS-ES mode.

* While signals from DTS-laser disc or CD are playing in another

Surround mode, you cannot switch to digital input or from digital input
to analog input by INPUT SETUP in SETUP MAIN MENU or A/D
button.

* The outputs for the VCR 1 OUT, DSS/VCR 2 OUT, TAPE OUT, and

CD-R OUT output analog audio signals. Do not record from CDs or
LDs that support DTS using these outputs. If you do, the DTS-
encoded signal will be recorded as noise.

NOTE for Dolby Digital Surround EX signal
* When playing Dolby Digital Surround EX-encoded software in 6.1

channels, it is required to set the EX/ES mode.

* Note that some of Dolby Digital Surround EX-encoded software

does not contain the identification signal.  In this case, set the EX/
ES mode manually.

NOTE for 96kHz PCM audio
* AUTO, Source- DIRECT, and STEREO modes can be used when

playing PCM signals with a sampling frequency of 96 kHz (such as
from DVD-Video discs that contain 24 bit, 96 kHz audio). If such
signals are input during playback in one of the other surround
modes, output from SR5300 will be muted.

* Certain DVD player models inhibit digital output. For details, refer to

the player’s operation manual.

* Some DVD formatted discs featured copy protection. When using

such disc, 96 kHz PCM signal is not output from the DVD player. For
details, refer to the player's operation manual.