Wayne-Dalton TORQUEMASTER 9100 User Manual
35
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the
Find a Dealer section online at www.wayne-dalton.com
oPT
io
Nal
iNST
alla
Tio
N
Determine center line of door. Mark vertical line at this
point, on the header wall. Raise the door slightly until the
top section reaches the highest point of travel (high arc)
point, on the header wall. Raise the door slightly until the
top section reaches the highest point of travel (high arc)
.
Using a level, mark this high arc point of travel on the header
wall
wall
, intersecting the vertical center line, as shown in fIG.
3.1 through 3.2.
Hold the wall bracket’s bottom edge to the
appropriate 1/2” - 1” (room permitting) above of the high
arc line and centered on the vertical line
arc line and centered on the vertical line
, as shown in fIG.
3.2
. Spot the wall brackets mounting holes on the header
wall and then refer to your
garage door operator manual
for pre-drilling and securing the
wall bracket to header.
Using the OPERATOR HOOk-UP CHARTS, refer to referenced
illustrations in fIG. 3.3 through fIG. 3.4 for correct arm hook-
up from trolley to operator bracket.
illustrations in fIG. 3.3 through fIG. 3.4 for correct arm hook-
up from trolley to operator bracket.
NoTe: Refer to your operator manual for specific details on
how to assembly the curved and straight arm, as shown in
fIG. 3.3 through fIG. 3.4.
how to assembly the curved and straight arm, as shown in
fIG. 3.3 through fIG. 3.4.
NoTe: Depending on your setup, you may or may not have to
cut straight arm to accomplish trolley settings, as shown in
fIG. 3.3 through fIG. 3.4.
cut straight arm to accomplish trolley settings, as shown in
fIG. 3.3 through fIG. 3.4.
Trolley installation for
low headroom
HIGH ARC
LOW
HEADROOM
TRACk
TOP
SECTION
LEVEL
FIG. 3.1
FIG. 3.2
FIG. 3.3
STRAIGHT
ARM
FIG. 3.4
CURVED
ARM
CUT STRAIGHT
ARM TO
ACCOMPLISH
TROLLEY
SETTING
oPeRaToR hook-uP chaRT FoR low heaDRoom
OPERATOR
MODELS
TYPE Of ARM bEING USED
PREfERRED
HOOkUP
REf.
ILLUSTRATIONS
AbOVE
OPTIONAL
HOOkUP
REf. ILLUSTRATIONS
AbOVE
qUANTUM/
CLASSIC
CURVED /
STRAIGHT
Fig. 3.4
STRAIGHT
Fig. 3.3
LINEAR
STRAIGHT
Fig. 3.3
N/A
N/a
LIfTMASTER
(SEARS)
CURVED /
STRAIGHT
Fig. 3.4
STRAIGHT
Fig. 3.3
GENIE
CURVED /
STRAIGHT
Fig. 3.4
STRAIGHT
Fig. 3.3
fROM
STEP 12
HIGH ARC
LINE
TYPICAL 1/2” - 1”
AbOVE HIGH ARC
VERTICAL
CENTER LINE
HEADER
TORqUEMASTER
®
COUNTERbALANCE