Vidikron PLASMAVIEW VP-103VHD User Manual

• You have multiple VHD Controllers and want to control them independently, as opposed 

to broadcasting commands from a single remote to all of them. In this scenario, you can 
use multiple remotes programmed to use different IR codes. Or, you can use a single 
remote and change the IR code as needed to address a specific device.

 

When you change a remote code on the VHD Controller, you must re-program your remote 
control to send that same code. To do this:

1.

Using a straightened paper clip or similar object, press and hold the 
CODE button on the remote control for approximately three 
seconds, or until the LED on the remote lights solid red. 

 

 
– OR –

 

 

 
If your remote control unit does not have a CODE button, press and 
hold the LIGHT button on the remote control for approximately 
three seconds, or until the LED on the remote lights solid red.

2.

Enter a new two-digit code between 00 and 31 inclusive. Use the 
16:9 button for “9” and the 4:3 button for “0.” Include a leading 
zero for single-digit codes; for example, enter 9 as “09.”

3.

The LED turns off to confirm the code change. If you enter an invalid code, the LED 
flashes for three or four seconds. Try again, entering a valid code.

Display Device: The options in the Display Device menu allow you to perform certain 
adjustments at the plasma display.

• Display Position: Select Display Position from the Display Device menu to perform the 

following display device adjustments (these are global, independent of any input):

• Select Left/Right or Up/Down and use the 

 or 

 buttons to fine-tune the displayed 

image position.

• Select Width or Height and use the 

 or 

 buttons to fine-tune the display device 

aspect ratio. 

• Select Pix By Pix from the Display Position menu and set it to Enable to have the 

PlasmaView VHD map a 1920x1080 input signal to 1080p HD panel pixels, displaying 
100% of the original content. By skipping the scaling process, the PlasmaView VHD can 
produce high-definition images in their original, 1:1 pixel form. 

 

 
When Pix By Pix mode is disabled, the picture source is scaled for over-scanning and 
97% of the original is displayed. Use this setting to minimize or elimate image flicker.