Ubiquiti Networks RD-3G30 Leaflet

M10X25 Carriage Bolt (Qty. 3)
M10 Washer (Qty. 3)
M10 Spring Lock Washer (Qty. 3)
M10 Nut (Qty. 3)

M16 Washer (Qty. 2)
M16 Spring Lock Washer (Qty. 1)
M16 Nut (Qty. 2)

6. Adjust Azimuth and Elevation

After a visual alignment of both elevation and azimuth, azimuth can be
adjusted by rotating the antenna while supported by the stabilizer bracket.
Elevation is adjusted by tightening/loosening the elevation rod.

When azimuth/elevation are set tighten nuts to approximately
14N-m(10 lb-ft) or less should the mounting pole show deformation.

5. Attach Antenna to Mounting Pole

Mounting bracket can accommodate 1.5"-4"pole.
Mount the antenna slightly above the stabilizer bracket as shown in figure 5
using the following parts:

M12X180 Carriage Bolt (Qty. 4)
M12 Washer (Qty. 4)
M12 Spring Lock Washer (Qty. 4)
M12 Nut (Qty. 4)

1. Install Feed to Dish

Install Feed to Dish by:

M4 Bolt-Springlock-Washer Assembly (Qty. 6)

The Dish/Feed are keyed so that the feed can only be installed one way.
To install, line up the alignment pin on the Dish with the hole on the Feed
as shown in figure 1.

2. Install Main Mounting Bracket and Elevation Rod

Put M12X180 Bolt on the Main Mounting Bracket. Install
Main Mounting Bracket and Elevation Rod to Dish by:

Pivot Points should be loose to allow mounting frame to move so that
elevation rod can be installed.

3. Install Rocket and Waterproof Cables

Model MD-5G34 and MD-3G30 go to step 4.

Install Rocket by lining up slots on Rocket/Dish bracket. Slide into place.

Install Waterproof Cables (Qty. 2) to Rocket/Dish connectors.
Rubber boot to be placed over connectors for weatherproofing.

4. Attach Stabilizer Bracket to Pole

Select location for Dish antenna and attach the stabilizer bracket to
mounting pole just below where Dish will be installed as shown in figure 4.
Tighten to 14M-m (10 lb-ft). Install Stabilizer Bracket to pole by:
M10X100 Bolt (Qty. 2)
M10 Washer (Qty. 2)
M10 Spring Lock Washer (Qty. 2)
M10 Nut (Qty. 2)