Sony Microscope & Magnifier snt-v User Manual

18

The 

 

 (COM1 and COM2) icons represent the

serial ports of the video network station. Use these
icons when an EVI-D30/D31/G20/G21 or HSR-1/1P/
2/2P is connected to the “COM1” or “COM2” ports to
set up serial port function and communications
parameters.

If a serial port has the Click “Save” icon enabled, the
video network station reboots and alarm memory
contents are erased, so check the alarm memory
contents, if necessary, before setting.

Click the “COM1” (or “COM2”) icon.
The screen displays the “Serial Port 1 Settings” (or
“Serial Port 2 Settings”).

Make the required settings. Available settings are
as follows.

Purpose

Pan Tilt

HSR (only
displayed for
COM1)

Click the “Save” icon when finished with the
settings.
The new settings are saved, the video network
station reboots, and the display changes as follows
depending on the selected usage.
• When [Pan Tilt] is selected, the “Pan Tilt

Settings” page appears. Refer to “Pan/Tilt Driver
and Video Camera ID Setup” below.

• When [HSR] is selected, the “Sony HSR

Settings” page appears. Refer to “HSR-1/1P/2/2P
Setup” on page 20.

• When “Modem” is selected, the “Modem

Settings” page appears. Refer to “Modem Setup”
on page 22. Also, to set up dial-up connection via
modem, refer to “ISP (Internet Service Provider)
Setup” on page 22.

Purpose

Serial
Mode
(only
displayed
for
COM1)

Baud
Rate
(bps)

Data Bits
(length)

Stop Bits

Parity Bit

Select this if an EVI-D30/
D31/G20/G21 is connected to
the port.
When selected, the “Pan Tilt”
icon shown below is added
next to the “COM1” or
“COM2” icon.

Select this if an HSR-1/1P/2/
2P is connected to the port.
When selected, the “HSR”
icon shown below is added
next to the “COM1” icon.

Select this if a modem is
connected to the port.
When selected, the “Modem”
and “ISP” icons shown below
are displayed.

 

Select this if no device is
connected to a port.

Select the appropriate interface type:
[RS232] for the EVI-D30/D31/G20/G21 and
HSR-1/1P/2/2P.

Select the transfer speed: Select [9600] for
the EVI-D30/D31/G20/G21, or [1200] to
[38400] as the HSR setting to match that of
the HSR-1/1P/2/2P.

Select [8] data bits for the EVI-D30/D31/
G20/G21 and HSR-1/1P/2/2P.

Select [1] stop bit for the EVI-D30/D31/G20/
G21 and HSR-1/1P/2/2P.

Select [None] for the EVI-D30/D31/G20/
G21 and HSR-1/1P/2/2P.

Modem
(only
displayed for
COM2)

None