SMART Technologies Unifi 45 User Manual
99-00881-20 A0
Appendix A: Remote Management of Your Interactive Whiteboard System
43
Query Commands
* This command bypasses internal buffering and generates a response immediately.
Projector Power Control Commands
** You must send the off command twice. The first command displays an on-screen message and the second
command shuts off the system. You must send the second command within five seconds before the first
command times out.
command shuts off the system. You must send the second command within five seconds before the first
command times out.
Command
Result
Response (On-Screen)
get fwver
Displays the ECP’s firmware version*
FW version = #
get bootver
Displays the ECP’s bootloader version*
Bootloader version = #
get input
Displays the projector’s input*
Input = #
get powerstate Displays the projector’s power state (Idle, Powering, On
or Cooling)*
Powerstate = #
get brightness
Displays the projector’s brightness setting
Brightness = #
get contrast
Displays the projector’s contrast setting
Contrast = #
get volume
Displays the projector’s volume setting
Volume = #
get lamphrs
Displays the number of hours the projector lamp has been in use Lamp hours = #
get syshrs
Displays the number of hours the interactive whiteboard system
has been in use
has been in use
System hours = #
get pjfwver
Displays the projector’s firmware version
Projector FW Version = #
get pjserial
Displays the projector’s serial number
Projector Serial Number = #
Commands
Result
Response (On-Screen)
off now
Turns off the Unifi 45 projector immediately
Turning off
off
Turns off the Unifi 45 projector normally**
Turning off
on
Turns on the Unifi 45 projector normally
Turning on