Sierra Wireless RAVEN 1X 20070914 User Manual
Configuration Commands
Rev 3.0B Feb.08
131
RS232 voltage levels:
Positive = Network coverage.
Negative = No coverage.
Negative = No coverage.
Tip: Flow control (AT\Q) will override this indication, so if you want to
use CTS to indicate network coverage, flow control has to be off
(AT\Q0).
use CTS to indicate network coverage, flow control has to be off
(AT\Q0).
*NUMTOIP=n
Convert 12 digit number to IP.
•
n=0 : Use as name.
•
n=1 : Use as IP address.
*PPPNOCARRIER=n
Provides a “No Carrier” message to a device connected to the
serial port using PPP or CHAP when the cellular connection
becomes unavailable.
serial port using PPP or CHAP when the cellular connection
becomes unavailable.
•
n=0 : Disabled (Default).
•
n=1 : Enabled.
TCP
This group includes commands specific to TCP serial commu‐
nications.
nications.
Figure 1-8: AceManager : TCP
S0=n
This register determines how the PinPoint X responds to an
incoming TCP connection request. The PinPoint X remains in
AT Command mode until a connection request is received.
DTR must be asserted (S211=1 or &D0) and the PinPoint X
must be set for a successful TCP connection. The PinPoint X
will send a “RING” string to the host. A “CONNECT” sent to
the host indicates acknowledgement of the connection request
and the TCP session is established.
incoming TCP connection request. The PinPoint X remains in
AT Command mode until a connection request is received.
DTR must be asserted (S211=1 or &D0) and the PinPoint X
must be set for a successful TCP connection. The PinPoint X
will send a “RING” string to the host. A “CONNECT” sent to
the host indicates acknowledgement of the connection request
and the TCP session is established.