Sierra Wireless RAVEN 1X 20070914 User Manual
Configuration Commands
Rev 3.0B Feb.08
148
one minute.In the first 5 minutes after PinPoint X powers up, power
down events are ignored to give the user time to change configura-
tions.
down events are ignored to give the user time to change configura-
tions.
SISE=n
Standby Ignition Sense Enable: the PinPoint X will monitor the
ignition sense on the power connector and enter the low power
consumption stand‐by mode when the ignition is turned‐off.
ignition sense on the power connector and enter the low power
consumption stand‐by mode when the ignition is turned‐off.
•
n=0 : Disable
•
n=1 : Enable
VLTG=n
Set or query the voltage level at which the PinPoint X goes into
low power mode.
low power mode.
•
n=0 : Ignore voltage for power control.
•
n=threshhold in tenths of volts
Example: ATVLTG=130 would place the modem in a low
power use, standby state if the voltage goes below 13.0V.
power use, standby state if the voltage goes below 13.0V.
Friends
Friends Mode can limit access to the PinPoint X from the
cellular network and the Internet. Friends mode is a basic
firewall.
cellular network and the Internet. Friends mode is a basic
firewall.
Caution: If you are using Friends Mode you will not be able to use
AceManager remotely or Telnet to the modem unless you are
contacting the modem from one of the configured IP addresses.
AceManager remotely or Telnet to the modem unless you are
contacting the modem from one of the configured IP addresses.
Note: Friends Mode will only prevent the PinPoint X modem from
receiving data from those IP addresses not on the Friends List. It
cannot prevent data, such as pings, from traversing the network to the
modem which may billable traffic even though the modem does not
receive the data.
receiving data from those IP addresses not on the Friends List. It
cannot prevent data, such as pings, from traversing the network to the
modem which may billable traffic even though the modem does not
receive the data.