Sharp DK-A10BK User Manual

Page of 30
28
DK-A10
DK-A10BK
References
Troubleshooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
General
Remote control
Tuner
 
CD player
iPod
 
Condensation
Sudden temperature changes, storage or operation in an extremely
humid environment may cause condensation inside the cabinet or on
the transmitter on the remote control.
Condensation can cause the unit to malfunction. If this happens,
leave the power on 
with no disc
 until normal playback is possible
(about 1 hour). Wipe off any condensation on the transmitter with a
soft cloth before operating the unit.
 
Symptom
Possible cause
The clock is not set to 
the correct time.
Is the ST switch set to the correct 
setting?
Did a power failure occur? Reset 
the clock.
When a button is 
pressed, the unit does 
not respond.
Set the unit to the power stand-by
mode and then turn it back on.
If the unit still malfunctions, reset it. 
No sound is heard.
Is the volume level set to “0”?
Are the headphones connected?
Symptom
Possible cause
The remote control does 
not operate.
Is the AC power cord of the unit 
plugged in?
Is the battery polarity correct?
Are the batteries dead?
Is the distance or angle incorrect?
Does the remote control sensor re-
ceive strong light?
Symptom
Possible cause
The radio makes unusual 
noises continuously.
Is the unit placed near the TV or
computer?
Is the FM antenna or AM loop
antenna placed properly? Move
the antenna away from the AC
power cord if it's located nearby.
Symptom
Possible cause
Playback does not start.
Is the disc loaded upside down?
Does the disc satisfy the 
standards?
Is the disc distorted or scratched?
Playback stops in the 
middle or is not 
performed properly.
Playback sounds are 
skipped, or stopped in 
the middle of a track.
Is the unit located near excessive 
vibrations?
Is the disc very dirty?
Has condensation formed inside 
the unit?
Symptom
Possible cause
No sound is produced.
No image appears on the 
TV/monitor.
The iPod is not playing.
The iPod is not properly 
connected to the unit.
Is the AC power cord of the unit 
plugged in?
The video cable is not properly 
connected.
The TV/monitor’s input selection 
is not properly set.
iPod will not charge
Wrong iPod adaptor is used.
The iPod is not making full contact 
with the iPod connector.
The main unit is in stand-by mode.