GE Ca-Zoom PTZ 70 Operating Guide
Everest Ca-Zoom
®
6.2
5
8.6 System Power
Power Cord
Attach the power cord to the receptacle in the back of the CCU. Plug the power cord into a
Attach the power cord to the receptacle in the back of the CCU. Plug the power cord into a
properly grounded power source.
Turn ON power switch
CAUTION:
CAUTION:
Do not turn on power with cables disconnected.
8.5 Attaching other Peripheral Devices
Keyboard
For text generation, attach supplied keyboard to connection located in front of the CCU
labeled Keyboard.
Note: The keyboard may be plugged in or removed after the PTZ has been turned on.
Output Devices (Monitors, VCR, others)
For connection of output devices, determine the type of video cable required for proper
For connection of output devices, determine the type of video cable required for proper
connection (S-Video or coaxial BNC). Connect the end of the video cable to the appropriate
video-out receptacle in the front of the CCU. Connect the opposite end of the same video
cable to the appropriate video-in receptacle of the output device.
video-out receptacle in the front of the CCU. Connect the opposite end of the same video
cable to the appropriate video-in receptacle of the output device.
Input Devices
For connection of input devices, determine the type of video cable required for connection
For connection of input devices, determine the type of video cable required for connection
(S-Video or coaxial BNC). Connect the end of the video cable to the appropriate video-in
receptacle in the front of the CCU. Connect the opposite end of the same video cable to
the appropriate video-out receptacle of the input device.
receptacle in the front of the CCU. Connect the opposite end of the same video cable to
the appropriate video-out receptacle of the input device.
8.4 Attaching Slip Ring Cable Reel (Optional)
Step 1.
Align the wide key on the female end of the patch cable (fig. 5) with the wide
notch on the top of the connector on the cable reel. Push the cable in and turn
the nut until it locks in place (fig. 6).
notch on the top of the connector on the cable reel. Push the cable in and turn
the nut until it locks in place (fig. 6).
Step 2
.
Align the wide key on the cable termination with the top of the cable connector
on the CCU. Push the cable in and turn the nut until it locks into place.
Figure 6
Figure 5