GE 15057-1 Leaflet

 

 

                            

15057-1                  7/15/09

TO ACTIVATE YOUR TIMER
1. Display - Remove the plastic film from display.
2. Installation - Plug the timer into a grounded outlet and wait for at least 
30 minutes to charge the built-in rechargeable battery. Once the battery 
has charged, unplug and press the “

RESET” button.

3. Set Current Time - While holding down the CLK (Clock) button, press 
the 

DAY, HR (Hour) and MIN (Minute) buttons to set the day, hour and 

minute. Note the 

AM or PM appears after the time.

4. Release the CLK (Clock) button.
Your Timer is now ready to be programmed. 
PROGRAMMING AN EVENT
1. Press the PROG button once. The display will read 

or if an event has already been programmed the current event will be 
displayed. It will show current settings if it has been previously The 
number 1 indicates that you are now programming Event until the day you 
choosen to program is displayed.
2. To select the day to be programmed press the DAY button repeatedly 
the display should show the day on which you want the timer to turn 

ON. 

The day options includes:
  

- All days of the week (

MO TU WE TH FR SA SU)

 

- Any single day of the week (for example 

WE)

 

- Weekdays only (

MO TU WE TH FR)

 

- Weekends only (

SA SU)

3. Press the HR and MIN buttons to select the time of day to turn the 
Timer 

ON press the HR button repeatedly to change from AM to PM.

4. Press the PROG button again. The display will read:

It will show current settings if it has been previously set.
5. Repeat steps 2 and 3 to program other events.
6. To set additional ON and OFF cycles (maximum of 7 events) press the 
PROG button and follow the procedures 2-5 above for each new ON/OFF 
event. When you are finished press the 

CLK button the display will now 

show the current time and the Timer will control the device plugged into it 
according to the programmed events.
REVIEWING EVENTS
Press the 

PROG button repeatedly and will cycle through 

all the programmed 

ON/OFF events. Press the CLK to return 

to normal operation.

CLEARING PROGRAMMED EVENT
Press the 

PROG button repeatedly to find the ON/OFF event you want to 

clear. While holding the 

MODE button down, press the PROG to clear the 

settings for the event.
ACTIVATING YOUR EVENTS
Automatic -  For controlled operation according to programmed events, 
press the 

MODE button repeatedly until AUTO is displayed.

Random - For random operation press the MODE button until RDM 
is displayed. The Timer will turn 

ON and OFF at +/- 30 Minutes of 

programmed events randomly.
Manual - For manual operation, press the MODE button until ON 
(to turn and remain on) or 

OFF (to turn and remain off) is displayed.

OPERATING THE TIMER
Plug the Timer into an outlet near where you want time your lighting or 
appliance. Plug the lighting or appliance into the Timer. Check and adjust 
the Timer setting if needed.

        is a trademark of the General Electric Company and is used under license to 
Jasco Products Company LLC, 10 E. Memorial Road, Oklahoma City, OK 73114. 
This Jasco product comes with a 1 year limited warranty.  
Visit www.jascoproducts.com for details.