Timex T128 User Manual

5

The Nap Timer allows you to set a 3rd alarm to wake you after a nap of up to 90 minutes without disturbing your regular 

alarm settings. The Nap timer settings are 5, 10, 15, 20, 30, 45, 60, 90 minutes and OFF The default Nap Timer setting is 5 

minutes. To adjust the amount of nap time:
•  Press the NAP button to activate the Nap Timer mode. The nap time display begins flashing. 
•  While the display is flashing press the NAP button repeatedly to adjust the nap time display 

to the desired setting. 

•  Release the NAP button when the display is showing the desired nap time. The display will return to current time after 5 

seconds. The new nap time setting becomes the new default and remains in the memory until you change it again.

•  To check the amount of nap time remaining press the NAP button once. The display will show the amount of remaining 

nap time for 5 seconds and then return to current time. 

•  When the Nap Timer counts down to “0”, the display flashes “n 0”, the alarm turns ‘On’ 

and gradually increases in volume to wake you gently.  The alarm sound continues for one 

hour and then shuts off automatically.  To stop the nap alarm immediately, press the NAP 

button again. 

•  To cancel the Nap Timer before it counts down to “0”, press the NAP button once to display 

the amount of remaining nap-time and then press and hold the NAP button for 2 seconds 

until the display shows “OFF”. The Nap Timer is cancelled. 

 

After 5 seconds the display returns to current time. 

Press the NITELITE button to turn the night light ‘On’ at it’s brightest setting. Continue to press the NITELITE button to adjust 
the brightness to the medium, low and ‘Off’ settings

If you prefer to reduce the display brightness for sleeping, press the SNOOZE bar once to select the medium setting or twice 
to select the low setting. Press once more to restore the display to maximum brightness.

This Timex alarm clock is equipped with a convenient USB charging port on the back panel that allows you to recharge many 
brands of mobile phones, portable music players, and other handheld devices that are supplied with USB charging cables. 
The output rating of the USB charging port is 500mA. 
To charge your device, connect the USB charging cable that was supplied with your handled device to the USB charging 
port on the back panel of this alarm clock.
IMPORTANT!  When  connecting  your  USB  cable  to  the  USB  port  on  this  alarm  clock  please  be  sure  that  the                          
USB symbol 

(plea

on your plug is facing down when you insert the plug into the USB port.

Observe the charging indicator on your device to confirm that it is charging. If your device is not charging when the USB 
selector switch is in the “A” position, slide the selector switch to the “B” position to begin charging.
Note: Charging time will vary depending on the charging current that your device requires. Therefore some devices will take 
longer to charge than others.