Klark Teknik U.S.A. Air Compressor DN540 User Manual
Chapter 3: Getting Started
DN540
10
Operator Manual
Connecting the power cable
Making sure that the mains power at the power outlet is off, connect the mains cable
supplied with your DN540 to the mains power outlet and then to the mains socket at
the rear of your unit.
supplied with your DN540 to the mains power outlet and then to the mains socket at
the rear of your unit.
Connecting the audio cables
Making sure that all equipment is switched off, connect your DN540 to the rest of your
audio equipment as shown in the following subsections. For more information on
balancing, see “Balanced/unbalanced audio” on page 37.
audio equipment as shown in the following subsections. For more information on
balancing, see “Balanced/unbalanced audio” on page 37.
Channel I/O pin-outs
The following shows the channel I/O pin-outs for the male and female XLR connectors,
on both balanced and unbalanced circuits.
on both balanced and unbalanced circuits.
Pin-out
Balanced I/O
Unbalanced I/O
1
Screen/ground
Screen/ground (not connected
at unbalanced end)
at unbalanced end)
2
Hot signal
Hot signal
3
Cold signal
Ground at unbalanced end
1
Male XLR
chassis
connector
3
2
1
3
2
Female XLR
chassis
connector
Rear of DN540