ICOM iPCR100 User Manual
8
2
PANEL DESCRIPTION
@4
KEYPAD [0]–[9], [•], [CE] (p. 17)
➥
[0] to [9] are used to input a receive frequency or mem-
ory channel directly.
ory channel directly.
➥
[•] (Decimal) button is used to set the MHz digit when in-
putting a frequency.
putting a frequency.
➥
[CE] (Clear) button is used to clear mistakes while in-
putting a receive frequency or memory channel.
putting a receive frequency or memory channel.
@5
IF FILTER BUTTONS [NAR]/[WID] (p. 20)
Push to change the IF filter in use. The [WID] button se-
lects a wider filter, the [NAR] button selects a narrower fil-
ter.
Push to change the IF filter in use. The [WID] button se-
lects a wider filter, the [NAR] button selects a narrower fil-
ter.
• Usable IF filters vary according to receive mode.
@6
SCAN STOP BUTTON [STOP] (p. 26)
Push to cancel scan operation.
Push to cancel scan operation.
@7
PROGRAMMED SCAN BUTTON [PROG] (p. 27)
Push to start/stop programmed scan.
Push to start/stop programmed scan.
• “PROG” flashes while scanning.
@8
SPAN +/– BUTTONS [SPAN+]/[SPAN–] (p. 34)
Push to select one of four levels for the band scope fre-
quency span.
Push to select one of four levels for the band scope fre-
quency span.
@9
AUTO MEMORY WRITE SCAN BUTTON [AUTO] (p. 29)
Push to start/stop auto memory write scan.
Push to start/stop auto memory write scan.
• “AUTO” flashes while scanning.
@4
@5
@6
@7 @8 @9
#1 #2 #3
#6 #7
#4
#5
#0