GE RH30 LED System Installation Guide

LED Refrigerated Display Lighting

Vertical & Horizontal Cases

GEPS6500NCMUL-SY

imagination at work

Read these instructions completely and carefully.

• The power supply must be supplied with 100-240 VAC,  
  50/60 Hz, and connected to an individual properly grounded  
  branch circuit, protected by a 15 or 20 ampere circuit  
  breaker or time delay fuse.
• Wiring must be 2 wire with ground and rated for 75°C (167°F). 
  All wiring must be done to NEC or local electrical codes.

Risk of electrical shock. Disconnect power before servicing or installing product. 
LED Retrofit Kit Installation requires knowledge of luminaires electrical systems. 
If not qualified, do not attempt installation. Contact a qualified electrician. Install 
this kit only in the luminaires that have the construction features and dimensions 
shown in the photographs and/or drawings. / Risque de choc électrique. Couper 
le courant avant de réparer ou installer le produit. LED Retrofit Kit d’installation 
nécessite la connaissance des systèmes luminaires électriques. Si vous n’êtes 
pas qualifié, ne tentez pas l’installation. Contactez un électricien qualifié. Installez 
ce kit seulement dans les luminaires qui ont les caractéristiques de construction 
et les dimensions figurant sur les photographies et / ou des dessins.

Risk of injury. While performing installations described, gloves, safety 
glasses or goggles should be worn. / Risque de blessure. Lors de l’exécution 
des installations décrites, des gants, des lunettes de sécurité ou des lunettes 
de protection doivent être portées.

• This lighting system must be connected to a grounded  
  metal, permanent wiring system, or an equipment grounding  
  conductor must be run with the circuit conductors and be  
  connected to the equipment grounding terminal.

• Installation to be performed by factory trained service  

 

  personnel only.
• For use inside a commercial refrigeration case with packaged   
  foods only.
• Use this unit only in the manner intended by the manufacturer.  
  If you have any questions, contact the manufacturer.
• Before installing, servicing or cleaning unit, switch power off    
  at the service panel and follow appropriate lock out/tag out    
  safety procedures

This device complies with part 15 of the FCC Rules. Operation is 

subject to the following two conditions: (1) This device may not cause 

harmful interference, and (2) this device must accept any interference 

received, including interference that may cause undesired operation. 

This Class [A] RFLD complies with the Canadian standard ICES-003. 

Ce DEFR de la classe [A] est conforme à la NMB-003 du Canada.

  This equipment has been tested and found to comply with the 

limits for a Class A digital device, pursuant to part 15 of the FCC Rules. 

These limits are designed to provide reasonable protection against 

harmful interference when the equipment is operated in a commercial 

environment. This equipment generates, uses, and can radiate radio 

frequency energy and, if not installed and used in accordance with 

the instruction manual, may cause harmful interference to radio 

communications. Operation of this equipment in a residential area 

is likely to cause harmful interference in which case the user will be 

required to correct the interference at his own expense.

GE 

Lighting

Installation Guide