Edirol V-44SW E1 User Manual

 

Setup and Settings Guide

 

Use the V-44SW’s component output for shows and other situations where the video is being output to plasma displays or 
high definition projectors

Make the following menu parameter settings. Set the parameters in accordance with your usage environment.

 

* Menu parameter numbers in the “HD/RGB SD” sub-menu differ.

 

The connected plasma display or hi-vision projector needs to be set up as follows.

 

1. Output

1: Output Format (1080i) Sw

 

,

 

 etc. Selects optimal format, e.g., “1080i” or “720p”, for the connected 

device.

5: Zooming

Set value to 100 or lower when entire screen is not being displayed, 
adjusting as you observe the screen being displayed.

3. HD/RGB Input

 

1: HD/RGB SD *
2: HD/RGB Ch1
3: HD/RGB Ch2
4: HD/RGB Ch3
5: HD/RGB Ch4

3: Pre Scaling Mode

There are times when the RGB video is not displayed fully on the 
screen. Set the “3: Pre Scaling Mode” to “Manual,” then adjust with 
the “4: Manual Pre Scaling” parameter.

4: Manual Pre Scaling

5: Scaling Type

There may be instances where the aspect ratio of video input with 
RGB or SD is not 16:9, it may be necessary to adjust the aspect ratio 
while observing the screen.
If satisfactory results cannot be obtained with “Full Scale,” “Fixed 
Aspect: Letter,” or “Fixed Aspect: Crop,” select “Manual.” After 
selecting “Manual,” adjusts the “6: Manual X Scale” and “7: Manual Y 
Scale” parameters. 

8. System

1: System Frame Rate

Select the format appropriate for the output device you are using.

 

Plasma display, high-definition projector, or other display

Set the input to “Component Input.”

VGA cable

Plasma Display 
or Other Display

HD Camera 

or Other Device

PC or Other Device

Composite cable
S-Video cable

D-sub-5BNC cable

D-sub-5BNC cable

V-44SW Rear Panel

DV Camera, Player,  

or Other Device

V-44SW_e.book 18 ページ ２００６年１０月２３日　月曜日　午後３時２５分