Craftsman CTS205 User Manual
CertainTeed Vinyl Siding Installation Guide
72
STUDfinder Installation System
for 12' Panels
for 12' Panels
The STUDfinder™ Installation System combines precisely
engineered nail slot locations with graphics to help ensure quick,
accurate and secure installation of CertainTeed siding panels on
homes with standard 16" or 24" o.c. frame construction.
engineered nail slot locations with graphics to help ensure quick,
accurate and secure installation of CertainTeed siding panels on
homes with standard 16" or 24" o.c. frame construction.
NOTE: In areas without special wind-load requirements, some
vinyl siding may be used in 24" o.c. construction. Check with
your local building code official for special requirements and
ICC-ES Evaluation Report ESR-1066 for special wind-load
requirements.
vinyl siding may be used in 24" o.c. construction. Check with
your local building code official for special requirements and
ICC-ES Evaluation Report ESR-1066 for special wind-load
requirements.
Standard 12' panels feature 10 nail slots every 16", with one of the
10 letters in the word “STUDfinder” centered directly under each
slot. Locate the first stud and fasten the siding to it in the center
of the nail slot. Ensure that nail/staple penetration is at least 3/4" to
comply with ASTM D4756 (specification for vinyl siding installation).
Notice which STUDfinder letter appears below the slot.
10 letters in the word “STUDfinder” centered directly under each
slot. Locate the first stud and fasten the siding to it in the center
of the nail slot. Ensure that nail/staple penetration is at least 3/4" to
comply with ASTM D4756 (specification for vinyl siding installation).
Notice which STUDfinder letter appears below the slot.
Go to the next repeat of the letter to find the next stud. For
example, if your first stud is at “T,” succeeding studs in 16" o.c.
applications will also be at “T” (every 10th slot).
example, if your first stud is at “T,” succeeding studs in 16" o.c.
applications will also be at “T” (every 10th slot).
When you apply the next panel, adjust the overlap as necessary to
line up with studs and repeat the steps above, but be aware that
the overlapping panels may not use the same letter as your initial
panel.
line up with studs and repeat the steps above, but be aware that
the overlapping panels may not use the same letter as your initial
panel.
In 24" o.c. applications with standard size siding panels, 2 letters
will repeat every other stud (every 15th slot). For example, if the
first stud is located at “S,” then the next will be at “i,” then “S,” then
“i,” etc.
will repeat every other stud (every 15th slot). For example, if the
first stud is located at “S,” then the next will be at “i,” then “S,” then
“i,” etc.