CLEAR KB-702GM User Manual
K B - 7 0 2 / K B - 7 0 2 G M T W O - C H A N N E L S P E A K E R S T A T I O N S
1 - 8
speaker or headset is controlled by the program level control. The program
input accepts a balanced or unbalanced line-level audio signal. If this input is
connected to the stage announce (SA) output of a main station it can be used
as a paging input. Since the level of this input is independently adjustable
from the intercom audio volume, it can be used to override the intercom
audio.
input accepts a balanced or unbalanced line-level audio signal. If this input is
connected to the stage announce (SA) output of a main station it can be used
as a paging input. Since the level of this input is independently adjustable
from the intercom audio volume, it can be used to override the intercom
audio.
The pinout of the program input connector is as follows:
Pin 1 --- Ground (shield)
Pin 2 --- + Signal
Pin 3 --- - Signal
Figure 1-6: Program-Input Cable Wiring
18. Option Board Jumpers: The three jumper plugs P1, P2, and P3 must be
installed when optional modules are not used. When the optional EB7-4W
four-wire or EB7-TW modules are used, both P1 and P3 must be removed.
In the KB-702GM, P2 is replaced by the VOX module. Save these jumper
plugs for possible future use after removing them. The KB-702 will not
operate without either these jumper plugs or the optional modules
installed.
four-wire or EB7-TW modules are used, both P1 and P3 must be removed.
In the KB-702GM, P2 is replaced by the VOX module. Save these jumper
plugs for possible future use after removing them. The KB-702 will not
operate without either these jumper plugs or the optional modules
installed.
Program Input
Cable Wiring
KB-702 Program
Input Connector
XLR
Connector
Pin 1
1
3
2
Pin 3