Arboria Seat and Back Leaflet

3” screw (12) 

Arbor Seat and Back 

PLEASE READ COMPLETELY BEFORE BEGINNING ASSEMBLY 

ASSEMBLY INSTRUCTIONS 

SEAT AND BACK INSTALLED IN ARBOR 

TOOLS YOU WILL NEED 

•  Philips screwdriver (electric driver recommended) 

•  Small hammer 

•  Tape measure 
•  Pencil 
•  Four 2” nails  

STEP 2

 

SEAT AND BACK  TO ARBOR  ASSEMBLY 

•  Determine the height you prefer for the bench seat, usually from 16” to 18” above 

ground. 

•  Deduct 4 3/4” from the height and mark that height on each “leg” of the arbor, this 

will locate the bottom of the seat support. 

•  Drive nails in each of the arbor posts at the marked places. 

•  Rest the seat on the projecting nails, line it up front and back with the arbor posts. 
•  Hold the seat firmly to the arbor post and drive 3” screws into all four posts. 

•  Position  back 4” above seat, use books or blocks to support the back and 

steady in place  

•  Position outer edge of back blocks flush with the arbor post. 

•  Secure  the back to arbor using 3” screws. 

STEP 3

 

1 5/8” screw (6) 

HARDWARE 

CHECK BOX FOR THESE CONTENTS 

Made in USA  2003 

•  Seat assembly 
•  Back rails (total 3) 

•  Back mounting block (total 2) 
•  Screws (total 18) 

STEP 1

 

•  Line up the outer  rails to the edge of the back block with the narrow 

end pointing upward.  

•  Secure the outer back rails using the 1 5/8” screws. Center the middle 

rail and secure using 1 5/8” screws. 

BACK ASSEMBLY 

Block narrow end 

Back rails 

4 3/4” 

4” 

LWO Corporation, 3841 N. Columbia Blvd., Portland, OR 97217  (503) 286-5372  (800) 459-8718  www.arboria.com