Weed Eater WET6500A Owner's Manual

The throttle control has been preset at the factory and 
ad just ment should not be necessary.  If adjustment is 
necessary, proceed as follows:
•      With engine not running, move remote throttle control 

lever to “FAST” position.

•      If throttle lever on engine touches high speed stop, no 

further adjustment is necessary.  If throttle lever does 
not touch high speed stop, continue with adjustment 
procedure.

•      Loosen cable clamp screw.
•      Move throttle lever up until it touches high speed stop, 

and hold in this position.

•      Tighten cable clamp screw securely.

The carburetor has been preset at the factory and ad just ment 
should not be necessary.  However, engine per for mance 
can be affected by dif fer enc es in fuel, tem per a ture, al ti tude 
or load.  If the carburetor does need ad just ment, contact 
your nearest authorized service center/de part ment

IMPORTANT:  NEVER TAMPER WITH THE ENGINE GOVERNOR, 
WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. 

 

OVER SPEED ING THE ENGINE ABOVE THE FACTORY HIGH 
SPEED SETTING CAN BE DANGEROUS.  IF YOU THINK THE 
ENGINE-GOVERNED HIGH SPEED NEEDS ADJUSTING, 
CONTACT YOUR NEAREST AUTHORIZED SERVICE CENTER/
DEPARTMENT, WHICH HAS THE PROPER EQUIP MENT AND 
EXPERIENCE TO MAKE ANY NEC ES SARY ADJUSTMENTS.