Manualsbrain.com
  1. Manuals
  2. Brands
  3. Spendor
  4. SR5 Loudspeaker
  5. User Manual

Spendor SR5 Loudspeaker User Manual

Download
Page of 9
SR5IM1.DOC 
 
  Page 5 of 9 
 
2   BRACKET AND CABINET INSTALLATION 
 
• 
Check that all loudspeaker cables have been prepared and installed. See section 3 Cables and 
Connections. 
 
• 
The cabinet is secured to the bracket with 2 x M6 hex-drive socket cap machine screws, 2 x spring 
washers and 2 x stainless steel bushes. See figure 8. ALWAYS store these components safely 
whenever they are removed. 
 
• 
Remove the two screws and washers using the supplied 5mm hex wrench and carefully detach the 
bracket from the cabinet. 
 
 
 
       Figure 8 
 
 
• 
Hold the bracket against the wall (or ceiling) in its final location and carefully mark the centres of the 
three holes. To ensure a neat installation make sure the bracket is level. See figure 9. 
 
• 
Place the bracket to one side. 
 
• 
Drill three 5.5mm diameter holes to a clear depth of 30mm. Insert the 3 wall-plugs. Screw the bracket to 
the wall using the supplied 3 x No 8 cross -head screws. Before tightening the screws check the 
orientation of the bracket. 
 
 
 
   
        Figure 9 
     
 
• 
Check that the 2 x bushes are correctly fitted to the cabinet. Carefully locate the cabinet over the bracket 
and fit the 2 x M6 screws and 2 x spring washers. Do not tighten the screws completely until all cables 
have been connected. Tighten the screws securely but do not use excessive force. 
 
• 
To adjust the cabinet angle, loosen the M6 screws slightly, adjust the cabinet, then re-tighten the 
screws. 
 
• 
Take care not to mark any wall coverings when using the hex wrench.