Zephyr 700 User Manual

The 700 receiver system is contained in a 3½" frame
and features  microcomputer electronics that control
and monitor operation of either one or two receiver
modules and the  LNB.  Primary power is normally
117  vac with 240 volt units available. Rack mounting
is optional.

v Input signal to the receiver is L band at

950-1450 MHz and is usually supplied by an
LNB with ±50 kHz stability.  

v
v A "relative" RF signal meter monitors amplitude

of the carrier at the demodulator of the first audio
channel.  The position of the meter needle may
be changed with the adjustment directly below
the meter.  Any variation from this setting will
then be due to a change in the strength of the
received signal.  Therefore, it may be used for
peaking the dish and/or day to day monitoring of
system stability, such as dish movement or

cable problems.

v Frequencies of the C or Ku band satellite and

the  SCPC frequency are entered through a
keypad.  --We use the satellite frequency, rather
than a  transponder number, because of the total
lack of any industry standard relating to a
transponder numbering system.  They are
displayed on the top line of the  backlit
alphanumeric readout.  The bottom line of the
readout gives the results of the fault-monitoring

duties of the processor.  The front panel of the
700 frame is sloped to make it easy to read the
LCD display and enter data through the keypad.

v The  audio meters are  backlit with LED's (low

brightnes level is normal).  Light is red if the
channel is in a signal failure (squelch) mode and
is green in normal or squelch defeat operation.    

v Squelch of the output audio signal is provided by

circuits that listen for high noise levels.  The
squelch may be defeated with front panel
switches located next to the audio meters. 

Standard receiver modules are for 15 or 7.5 kHz
audio signals, with others available on special order.
Baby boards on the receiver modules contain audio
process/companding circuits for the particular
system.  Deemphasis time is selected with jumpers.
Both balanced and unbalanced output connectors
are provided on the rear panel.

A 70 MHz output is provided for use with external
demodulators.  Mode C contacts of a fault-alarm
relay are available at the back panel

General Information  MA700OVW.sam

SECTION 11