Shakespeare Electronic 5225-XP Leaflet

Page of 1
Galaxy
®
 Style 5225-XP
Thank you for purchasing a Shakespeare antenna product. 
Customer comments are welcome. Before installing, please study 
the diagram and check parts supplied against those listed.
IMPORTANT! Please read all instructions before installing.
The Style 5225-XP is a Galaxy
®
 Series, collinear-phased           
5/8-wave antenna of 8’ overall length. The one-section, 6dB antenna 
has a stainless steel ferrule and a 20’ RG 8/X low-loss cable.
Tools required:  Soldering iron (40-watt min., 75-watt 
max.), resin core solder, pocket knife, wire cutters.
Installation Instructions
Choose a mounting location that is as high as feasible, as free 
as possible from obstructions, and as far as possible from other 
antennas and strong sources of RF. The recommended mount 
is Shakespeare’s Style 5187 stainless steel ratchet mount (sold 
separately). This antenna can be mounted self supporting.
1.  Mount the antenna according to the directions included with 
the mount you choose.
2.  Route the cable to your transceiver, keeping it as far as 
possible from other electrical equipment and cables. Any excess 
cable should be rolled in a coil of at least 8” diameter and stowed in 
an out-of-the-way place away from other electrical cabling.
3.  Attach the PL-259 connector according to the instructions 
packed with the connector.
Cleaning Instructions
To clean the antenna, use mild dishwashing liquid (one that is not 
harsh to the hands and without ammonia) in lukewarm water.
WARNING:  Do not let paint solvents, cleaning solvents, or adhesive 
caulking come in contact with the antenna. Chemicals in these materials 
might destroy the finish.
©2004, 2005 Shakespeare Co.        · Form I-5225-XP  J: rev. 08/03/2012
35-90-1288-00
Supplied Parts
1  Antenna assembly
1  PL-259 Connector with instruction sheet
1  Grommet plug (see Tech Tips)
Coax cable
To VHF transceiver
One-section
Antenna
Tech Tips
This antenna will read “short 
circuit” when tested with an ohm 
meter or continuity tester.  
The  50-ohm coaxial cable 
should remain at least 3 feet 
in length, measured from the 
point where the cable exits the 
antenna.
For installations where the cable 
exits through the bottom center 
of the antenna’s ferrule, replace 
the grommet at the exit hole 
in the ferrule with the supplied 
Grommet Plug.
PL-259 Connector
Shakespeare Electronic Products Group
U.S. Operations: 6111 Shakespeare Rd. · Columbia, SC 29223 · 803-227-1590 · Fax: 803-419-3099 · www.shakespeare-marine.com
U.K. Operations: Enterprise Way, Fleetwood, Lancashire, FY7
 
8RY, England · +44 (0) 1253 858787 · Fax: +44 (0) 1253-859595 · www.vtronix-antennas.com
Shakespeare Co., LLC is a subsidiary of Jarden Corporation (NYSE: JAH)