Siemens TV Converter Box 611 User Manual
General safety guidelines
1.3 Use for the intended purpose
1.3
Use for the intended purpose
DANGER
There is a risk of death, serious personal injury and/or serious material damage when direct
drives or their components are used for a purpose for which they were not intended.
The motors are designed for industrial or commercial machines. It is prohibited to use them
The motors are designed for industrial or commercial machines. It is prohibited to use them
in areas where there is a risk of explosion (Ex-zone) unless they are designed expressly for
this purpose (observe the separately enclosed additional instructions where applicable). If
increased demands (e.g. touch protection) are made in special cases – for use in non-
commercial systems – these conditions must be ensured on the machine side during
installation.
Direct drives and their components may only be used for the applications specified by the
Direct drives and their components may only be used for the applications specified by the
manufacturer. Please contact your Siemens branch responsible if you have any questions
on this matter.
The motors must be protected from dirt and contact with aggressive substances.
Special versions and design variants whose specifications vary from the motors described
The motors must be protected from dirt and contact with aggressive substances.
Special versions and design variants whose specifications vary from the motors described
herein are subject to consultation with your Siemens branch.
The motors are designed for an ambient temperature range of -5 °C to +40 °C. Any
The motors are designed for an ambient temperature range of -5 °C to +40 °C. Any
alternative requirements specified on the rating plate must be noted! The on-site conditions
must comply with the rating plate specifications and the condition specifications contained
in this documentation. Any differences regarding approvals or country-specific guidelines
must be taken into account separately.
DANGER
The products included in the scope of delivery are exclusively designed for installation in a
machine. Commissioning is prohibited until it has been established that the end product
conforms with Directive 98/37/EC. All safety instructions must be observed and given to the
end user for his/her information.
DANGER
Risk of electric shock if a hazardous voltage is present on the stator when operated as a
single component.
To ensure that the components have sufficient shock-hazard protection, voltage must only
To ensure that the components have sufficient shock-hazard protection, voltage must only
be applied to the motors once they have been installed.
1FW6 Built-in torque motors
16
Configuration Manual, 05/2009, 6SN1197-0AD00-0BP7