Paxton Automotive PAXTON 1220 User Manual

12-1

Section 12

AIR FILTER ASSEMBLY

Place the Paxton air filter cover against the
inner fender just behind the right headlight.
Use it as a template to mark and drill two
3/32" holes. Do not install the cover at this
time.

Insert the mass air flow (MAF) sensor into the
back of the air filter cover. Place the air filter
with clamp (from the inside) over the protrud-
ing MAF and the air filter flange. Rotate the
MAF so that the connector runs parallel to the
top as shown. Tighten the clamp.

Mount the air filter assembly behind the head-
light and secure with the sheet metal screws
provided.

Attach the 3-1/2" molded elbow to the super-
charger with the sleeve and clamps.

Connect the 3-1/2" flex tube to the molded
elbow and the back of the MAF with the 3" x
1" adapter sleeve on the MAF (as a spacer)
and secure with clamps.

Connect the air discharge tube to the throttle
body and supercharger with the sleeves and
clamps provided.

Clamp the provided rubber cap onto the vent
fitting on the throttle body.

With the 3/8" rubber hose, route blowby to
the air filter cover through the inline filter
provided.