Panasonic Attune II Operating Guide

Setting the unit

wAuto-Talk-Lock setup

For a headset where Auto-Talk-Lock is set up, it has a
function to select “TALK” automatically when the vehicle
detector has become active, and you can talk with the
customer at the menu board. One unit of this product or the
Belt Pack (or the Order Taker) can be set to Auto-Talk-Lock
setup per lane.

p Complete ID Registration, to do this setting.

p You can set only the unit with its DIP switch No.1 in

the ON position.
(Refer to p. 20 “DIP switch setup”.)

Press the [POWER] button to turn on the
power.

p When the power is turned on, the voice messages

“Hello”, “Headset xx” (xx: ID number registered in the
Center Module) and “Lane x” (x: Connected Lane
number) are heard from the earphone.

Press the [T1] button* while the power
indicator turns green and red alternately for 3
seconds.

p Auto-Talk-Lock registration is performed to Lane A.

When registration is complete, the voice message
“Auto Talk ON” is heard from the earphone, and the
power indicator stops turning alternately.

p When the [T1] button of this product is not pressed

within 3 seconds after the power is turned on, the
voice message “Auto-Talk-Lock OFF” is heard from
the earphone, and the unit starts as usual.

* Use the [T2] button to register Auto-Talk-Lock for

Lane B.

p If there is a problem registering Auto-Talk-Lock,

an error beep and the voice message “Failed” are
heard from the earphone, and the power indicator
blinks red to alert the user the abnormal state. If
that happens, turn off the headset and retry from
step .

p If the power of the headset is turned off, all the setting

conditions for Auto-Talk-Lock will be canceled. This
setting should be carried out without fail when the
power supply is started up.

p A headset in which the Auto-Talk-Lock function

has been enabled operates at the Talk-Lock setting
regardless of the DIP switch No.2 setting.

Note

wID registration

Before using this product, the unit ID must be registered in
the Center Module. After the ID is registered in the Center
Module, wireless communication between this product and
the Center Module is enabled.

Set the Center Module to “ID Registration”
mode.

(Refer to the operating instructions of the Center
Module.)

Hold down the [POWER] button for 2 seconds
or more to turn off the headset.

Press the [POWER] button for 1 second or
more while holding down the [T1] and [T2]
buttons to turn on the power.

p The headset enters the ID Registration setting mode.

You will hear “Registration Mode” and the power
indicator will blink orange.

Press the [T1] button.

p You can hear “Connecting Center Module A” and the

lane Indicator will blink orange.

p When the Center Module is WX-CC412, ID

registration for Lane B is automatically started, the
voice message “Connecting Center Module B” is
heard from the earphone, and the lane indicator
blinks green.

p When the ID Registration succeeds, you will hear

“Registration complete”, “Headset xx” (xx: ID number
registered in the Center Module), and the power
indicator stops blinking and stays on.

p If ID registration fails, an error beep and the voice

message “Failed” are heard from the earphone,
and the power indicator blinks red to indicate an
abnormal state. If that happens, retry from step 2.

When the ID registration is complete, cancel
“ID Registration” of the Center Module.

p When this is done, “ID Registration” of this product is

cancelled and the power indicator turns green.

p During ID registration, the other headsets or the Belt

Packs (or the Order Takers) cannot be used to talk or
page.

Note