TOA Electronics N-CC2360 User Manual
12
No.
1
2
3
4
5
6
IN 1
IN 2
C
OUT 1
OUT 2
C
Contact input 1
Contact input 2
COM
Contact output 1
Contact output 2
COM
Terminal Name
Contact name
Day/ Night
Select Contact input 1
or Contact input 2.
COM
IN
GND
1 2 3 4 5 6
Color: Open
Black & white: Closed
Black & white: Closed
The figure shows that IN1 Contact
Input/Output terminal is set to
Day/Night Input terminal position.
Input/Output terminal is set to
Day/Night Input terminal position.
24V
24V
2 1
1 2 C 1 2 C
10/100M
AUDIO
OUT
MONITOR
OUT
OUT
IN
CONTACT
RDY BUSY ERR
FD/COL
LINK
/ACT
/ACT
• Contact Output
There are two contact outputs, allowing external connected device control and contact bridging between video
network system devices. For details, refer to the Setup Manual.
There are two contact outputs, allowing external connected device control and contact bridging between video
network system devices. For details, refer to the Setup Manual.
Applicable cables
Solid cable:
Solid cable:
AWG28 (ø 0.32) – AWG22 (ø 0.65)
Stranded cable: AWG28 (0.08 mm
2
) – AWG22 (0.32 mm
2
)
Note: Strip the cable sheath approximately 10 mm, then insert the cable while pushing down the button on the
terminal with a screwdriver.
• Contact Input
There are two no-voltage contact inputs for connection of sensor trigger signals, etc. A contact can be
automatically established between the transmitter and the network video receiver or network digital recorder
when a signal enters the contact.
Setting the contact input to Day & Night mode forcibly, shorting (making) the Day/Night input terminal forcibly
switches the display to B&W mode, which increases the camera’s sensitivity. For details, refer to the Setup
Manual.
There are two no-voltage contact inputs for connection of sensor trigger signals, etc. A contact can be
automatically established between the transmitter and the network video receiver or network digital recorder
when a signal enters the contact.
Setting the contact input to Day & Night mode forcibly, shorting (making) the Day/Night input terminal forcibly
switches the display to B&W mode, which increases the camera’s sensitivity. For details, refer to the Setup
Manual.
Note
The Day & Night function can also be set using the camera menu. If "Normal," "Motion," or "Color" has been
selected for the Day & Night function, the display could repetitively switch between color and black-and-white
modes when the camera is used under phototransmitter. In such cases, select "Day & Night" in the "Contact
Input" settings, and synchronize the phototransmitter power supply with the switch to black-and-white mode.
The display mode changes as follows if the Contact Input has been set to "NO" (Normally Open):
The Day & Night function can also be set using the camera menu. If "Normal," "Motion," or "Color" has been
selected for the Day & Night function, the display could repetitively switch between color and black-and-white
modes when the camera is used under phototransmitter. In such cases, select "Day & Night" in the "Contact
Input" settings, and synchronize the phototransmitter power supply with the switch to black-and-white mode.
The display mode changes as follows if the Contact Input has been set to "NO" (Normally Open):
Infrared phototransmitter power "ON" :
B&W mode (close)
Infrared phototransmitter power "OFF" : Color mode (open)
10. ABOUT THE CONTACT INPUT/ OUTPUT TERMINAL