TIC AMP10 User Manual
E
E
x
x
t
t
e
e
r
r
i
i
o
o
r
r
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
…
…
This TIC AMP10 exterior receiver amplifier can connect to and operate
three different sound sources at any one time.
Step by step…
1. Installation of your amplifier should consider a safe, off the ground,
dust free position not too far from a mains outlet and not exposed to
excess water, dust, particulate matter or human traffic conditions
excess water, dust, particulate matter or human traffic conditions
2. Connect any pre-run outdoor speakers or output devices to your
AMP10 receiver amplifier
3. Connect any input devices such as your CD/ MP3/Ipod players etc. to
your AMP10 receiver amplifier
4. Connect the rear 12v power cable to your AMP10 and then tighten the
connection securely.
5. Connect the rear cable to the supplied 12v transformer.
6. Connect the power mains cable to the 12v transformer and then to the
6. Connect the power mains cable to the 12v transformer and then to the
wall mains 120/110v. Please be especially cautious with the integrity
of this connection to dangerous mains power. Ensure its in a safe and
dry environment.
of this connection to dangerous mains power. Ensure its in a safe and
dry environment.
7. Switch the unit “on” using the rear silicone material clear covered
rocker switch
8. Switch the unit “on” using the front fascia on/off/ pause push switch
9. Choose your listening “Mode”. Note: the unit is factory preset in Radio
9. Choose your listening “Mode”. Note: the unit is factory preset in Radio
mode to begin initially
10. Select desired input device CD, MP3 or radio/ mic’s input/ output
11. Test the unit using as many “modes” of operation as you can to
11. Test the unit using as many “modes” of operation as you can to
ensure a correct trouble free exterior installation
Sit back & Enjoy!
TIC Corporation wishes you many years of pleasure
from your new TIC Corporation exterior audio product