Tektronix Camcorder 2200 User Manual
3-34
Section 3 — Menu Descriptions
3.
Set the
CONTROL DELAY
to
6 fields
4.
PORT ASSIGN
is set automatically to
PORT A1
. The baud rate
for Port A1 is fixed at 307 Kbaud.
5.
Set
CHANNEL ROUTING
for
BOTH
or
SWR IN,
depending upon
your system configuration, as described in “DPM
Configurations” in the Model 2200 User Guide.
Configurations” in the Model 2200 User Guide.
6.
Press the CPU Reset button through the hole in the door of the
switcher frame.
switcher frame.
Communication should now be established between the Model
2200 and Krystal.
2200 and Krystal.
For Krystal:
1.
Set the
DPM TYPE
to
KRYSTAL.
The values denoted in Steps
2 through 4 are set automatically.
2.
Turn the
EFF SEND DELAY
soft knob to select
5 fields
. It is
important to set this delay correctly.
3.
Turn the
CONTROL DELAY
soft knob to select
6 fields
.
4.
PORT ASSIGN
is set automatically to
PORT A1
. The baud rate
for Port A1 is fixed at 307 K baud.
5.
Set
CHANNEL ROUTING
for
BOTH
or
SWR IN,
depending upon
your system configuration, as described previously under
“DPM Configurations.”
“DPM Configurations.”
6.
Reset the Control Processor in the Model 2200 Signal
Processor frame. This is done by opening the front door of the
Processor and pressing the
Processor frame. This is done by opening the front door of the
Processor and pressing the
RESET
button located near the
top of the Control Processor module.
Communication should now be established between the Model
2200 and Krystal.
2200 and Krystal.