Tektronix Camcorder 2200 User Manual

Page of 316
2-43
Effects Memory Subpanel
Initiate sequences by pressing the following buttons:
SEQ
register 
The sequence starts at the register indicated, and proceeds 
through the linked sequence to the last register. If a loop has been 
programmed, the sequence loop continues until the 
SEQ
 button is 
pressed to terminate the sequence.
A sequence loop can be broken by double-pressing a register 
button, clearing the sequence link that existed in that register, and 
making the invoked register the last register in the sequence.
During a sequence of registers with multiple levels, the 
SEQ
 
button will high tally if any of the enabled levels was learned with 
a sequence. However, it may be that not all enabled levels are 
sequencing.
Different sequence delays may be learned separately into 
different enabled levels. Sequence delays on different levels are 
completely independent, and thus the sequencing may be 
occurring at different times on different levels.
If an E-MEM level is disabled while it is actively sequencing, the 
sequence will continue. Turning off the 
SEQ
 button will not halt 
the sequence, because the sequencing level is not delegated. To 
ensure halting all actively running sequences, all E-MEM levels 
must be enabled (
ENABLe ALL
) and then
 SEQ
 turned off.
EFFect DIS
 causes an S-linear transition from the current state to 
the next recalled register. The current state may be a setup you 
have just done on the control panel or the state resulting from a 
register recall.
An effects dissolve may be learned into a register, so that recalling 
that register will initiate a dissolve to another specified register. 
The following button sequence is used to learn a dissolve 
(parameters in angle brackets (<...>) are optional): 
NOTE:  
Only areas which are enabled will be learned. For more 
information read 
Effect
Dis