Thorens TEM 3200 User Manual
Connecting the TEM 3200
8
Speaker outputs
�
The TEM 3200 uses the outstanding loudspeaker terminals of WBT,
Germany. These have been proven to provide perfect contact over
many years in millions of sets.
Germany. These have been proven to provide perfect contact over
many years in millions of sets.
Connect the positive input jack of your loudspeaker (usually marked
red) with one of the red marked output jacks on the rear panel of the
TEM 3200. You can choose either of them. Repeat these instructions
for the negative jack.
red) with one of the red marked output jacks on the rear panel of the
TEM 3200. You can choose either of them. Repeat these instructions
for the negative jack.
You can insert the bare loudspeaker cable by loosening the knob,
inserting the wire from the side and then tightening the knob again.
You can do the same with spades at the ends of your cables or use
banana plugs (they can simply be plugged in from the rear).
inserting the wire from the side and then tightening the knob again.
You can do the same with spades at the ends of your cables or use
banana plugs (they can simply be plugged in from the rear).
Always assure that the cables are fixed tightly and do not al-
low the wire to protrude and touch other terminals or wires!
low the wire to protrude and touch other terminals or wires!
Do not use a cord with different configuration!
To unplug the balanced XLR cord from the input jack, push the tab
above the jack and unplug it.
above the jack and unplug it.
With the RCA adapter shipped with this unit you can also use unbal-
anced RCA cords. The signal balancing is performed inside the TEM
3200 by an excellent signal transformer.
anced RCA cords. The signal balancing is performed inside the TEM
3200 by an excellent signal transformer.
Pin 1: Ground
Pin 2: Positive (non-inverted) signal
Pin 3: Negative (inverted) signal
Pin 2: Positive (non-inverted) signal
Pin 3: Negative (inverted) signal
Pin configuration:
This amplifier is floating at the output jacks.
Never ground either one of the jacks.
Never ground either one of the jacks.
Do not connect active subwoofers to the speaker
outputs and do never short-circuit the output
jacks or the loudspeaker wires when connected.
The unit will be damaged severely!
outputs and do never short-circuit the output
jacks or the loudspeaker wires when connected.
The unit will be damaged severely!