Troy-Bilt CSV 060 Push Chipper Shredder Vac Owner's Manual

• 

Always observe safety rules when performing any 

maintenance.

• 

The warranty on this chipper/shredder vacuum does not 

cover items that have been subjected to operator abuse or 

negligence. To receive full value from warranty, operator 

must maintain the equipment as instructed here.

• 

Changing of engine-governed speed will void engine 

warranty.

• 

All adjustments should be checked at least once each 

season.

• 

Periodically check all fasteners and make sure these are 

tight.

Always stop engine, disconnect spark 

plug, and ground against engine before performing 

any type of maintenance on your machine.

1. 

Lubricate each wheel shoulder screw (rear wheel) and pivot 

arm axle (front wheel) once a season with light oil.

2. 

Lubricate the pivot points of the nozzle height adjustment 

levers once a season with light oil.

3. 

Lubricate the locking rod with light oil to ease the 

application of attaching on or removing bag.

4. 

Lubricate the nozzle/hose vac lever on top of the nozzle 

once a season with light oil. See Figure 6-1.

5. 

Follow the separate engine manual packed with your unit 

for lubrication instructions.

• 

Clean the chipper/shredder vacuum thoroughly after each 

use.

• 

Wash bag periodically with water. Allow to dry thoroughly 

in shade.

• 

If the flail screen becomes clogged, remove and clean as 

instructed below.
NOTE: Cleaning with a forceful spray of water is not 

recommended as it could contaminate the fuel system.

Refer to the Engine Operator’s Manual packed with your chipper/

shredder vacuum for all engine maintenance.

Before performing any type of 

maintenance on the machine, wait for all parts to 

stop moving and disconnect the spark plug wire. 

Failure to follow this instruction could result in 

personal injury or property damage.