One Stop Gardens Landscape Lighting 91072 User Manual

The Smiling Frog Solar Light must be set on a flat, even and stable surface.  The Smiling Frog Solar 
Light is water resistant to protect against normal daily elements.  

2. 

The Smiling Frog Solar Light will need to charge for at least six hours before using it for the  

 

first time. 

3. 

Located on the bottom of the Smiling Frog Solar Light is a panel with a “ON”/”OFF” 

 

Button (1)-see Figure 1.  Pressing down on the “ON”/”OFF” Button (1) will turn the Smiling  

 

Frog Solar Light on or off.  After the initial charge (Step 2) is set, check to see that the 

 

Light (3) is on by viewing the Smiling Frog at night or in a dark location.  If the Light (3) is not  

 

lit, press the “ON”/”OFF” Button (1) again until it is in the “ON” position-see Figure 1.  

Figure 1 

“ON”/”OFF” Button (1)

 

Note:  During the day, the Solar Panel (2) converts sunlight into electricity, recharging the batteries.   
 

The amount of light the Solar Panel (2) receives depends on placement of the Smiling Frog  

 

Solar Light, geographic location and weather.  If the weather is cloudy and the panel did not  

 

receive a full charge, the Smiling Frog Solar Light may not achieve the full eight hours of   

 

operating time.  It will catch up on its own after two to three days of full sun.

NOTE: Before performing any maintenance, make sure the “ON”/”OFF” Switch (1) is in the “OFF”  
 

position.  

1.   

Located on the bottom of the Smiling Frog Solar Light is a panel held in place with four     

 

small Phillips Head Screws (4)-see Figure 1.  Place the Smiling Frog Solar Light over a    

 

working surface that is flat and clear of debris so that you may easily retrieve the Phillips   

 

Head Screws if they are dropped.  Using a small Phillips Head screwdriver (not included),  

 

remove each of the Phillips Head Screws (4). Place the Phillips Head Screws (4) in a secure  

 

location.  Pull off the Top Panel (5) of the Battery Compartment.  

2. 

Remove the Rubber Panel (6) from the Battery Compartment-see Figure 2.   Pull out the   

 

Batteries (7) and replace with two new Batteries (7)-see Figure 3.  

Caution: 

Make certain that the batteries are installed with the positive and negative poles    

 

 

as indicated.  Use Ni-Cad Batteries only.

“ON”/”OFF” Button (1)

Top Panel (5)

 Phillips Head Screw (4)

 Phillips Head 
Screws (4)

Rubber 
Panel (6)