Nortel Networks Water System BCM 1000 User Manual

Appendix B Initializing the system

BCM 4.0 for BCM1000 Installation and Maintenance Guide Addendum

After you start the BCM system, you are ready to set the initial configuration parameters. 

The initial configuration defines your BCM system to the network. It also gives the system a 
unique identity and initial parameters. From that point, you can continue with the specific 
configurations for your system, which are described in the BCM 4.0 Administration Guide and the 
other user guides for each optional application you choose to add to your system.

Obtain the following parameter values from an Internet service provider (ISP) or corporate 
network administrator.

•

initial IP address and netmask for each network interface

•

primary (and optional secondary) DNS servers

•

default next-hop router

•

fractional T1 channel numbers (if you are using fractional TI)

•

system name

•

WAN link protocol

•

frame relay DLCI/CIR (if applicable)

•

V.90 or V.92 modem settings (North America only)

All BCM systems are shipped with this default address:

•

IP address:  10.10.10.1

•

Subnet:  255.255.255.0 

If you can use the default IP address, you can connect the BCM system to the LAN. This enables 
you to configure the BCM system, through Element Manager, from any PC connected to the LAN. 

You can also connect to the BCM system using an Ethernet crossover cable (see 

) or through the serial port (

). 

Warning: Before using the default address on your network, check with your system 
administrator. If this address conflicts with the LAN settings, you can cause network 
damage if you connect to the network without changing the IP address.