Oricom WNS1 User Manual

 

 

- 5 - 

 

 
 
SETTING THE TIME (       ) 
 

-  Press and hold       (set clock) button.  
-  Press H (hour) and M (minute) until correct hour and minutes appear on the display.  
-  Release      (set clock) button.  
-  For p.m. hours, the p.m. indicator will appear on the display near the inscription PM. 

 
SETTING THE ALARM TIME (        )  
 

-  Press and hold      (set alarm) button.  
-  Press H (hour) or M (minute) until correct hour and minutes appear on the display.  
-  Release      (set alarm) button.  
-  Press      , H and M to reset the alarm clock to 12.  

 
SETTING THE ALARM MODE  
 
Put the function switch on A+T position. Choose which alarm mode you wish to be awakened to by 
moving the alarm mode switch to one of the following selections: 
 
V 

only shaker activated 

 
V+S  : 

both sound and shaker alarm activated  

 
F+V  : 

both strobe light and shaker alarm activated 

 
When the alarm is set to one of the alarm modes, the alarm indicator will appear on the display near 
the inscription AL. 
The table below shows how the alarm modes indicate an incoming call from the alarm clock.  
 
ALARM MODE 

ACTION 

ALARM CLOCK 

INCOMING CALL 

SOUND  

Buzzer 

Continuous 

With pauses 

SHAKER 

Vibrates 

Continuous 

With pauses 

STROBE LIGHT 

Flashes 

Continuous 

With pauses  

 
 
SNOOZE BUTTON         / STROBE LIGHT 
 
When the alarm sounds, you can use the 

  snooze button to temporarily turn off the alarm. The 

alarm will come on again after 9 minutes. This sequence can be carried out for up to 2 hours after 
which the alarm mode will be automatically switched off.  
 
SWITCHING THE ALARM OFF  
 
Press the alarm off button (OFF), the alarm will them operate at the same time the next day. The 
alarm if not switched off will continue to sound for up to 2 hours and then be automatically switched 
off.