Netgear DG834GSP User Manual
NETGEAR VPN Configuration
B-1
v1.0, June 2007
Appendix B
NETGEAR VPN Configuration
DG834GSP to FVL328
This appendix is a case study on how to configure a secure IPSec VPN tunnel from a NETGEAR
DG834GSP to a FVL328. This case study follows the VPN Consortium interoperability profile
guidelines (found at
DG834GSP to a FVL328. This case study follows the VPN Consortium interoperability profile
guidelines (found at
).
Configuration Profile
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
Table B-1.
Profile Summary
VPN Consortium Scenario:
Scenario 1
Type of VPN
LAN-to-LAN or Gateway-to-Gateway (not PC/Client-to-Gateway)
Security Scheme:
IKE with Preshared Secret/Key (not Certificate-based)
IP Addressing:
NETGEAR-Gateway A
Static IP address
NETGEAR-Gateway B
Static IP address