Sterling Plumbing Musical Table 882.00252.00 User Manual

3–Pump 33-Station Controllers 

Chapter 3:  Installation 

24 of 51 

4. 

As appropriate, setup the rest of the pumps using either of the following methods: 

•  Copy this pump’s settings to one or more other pumps, as described 

below 

•  Use the Back or Next buttons to navigate to other pumps. Touch 

Back to go to the previous “Pump Setup” screen, or touch Next to go 
to the next “Pump Setup” screen. 

•  Touch Goto and enter a pump number to go to that pump’s setup 

screen . 

If other pumps at your facility will use the same settings as a pump you have already set up, 
you can copy the settings from this pump to the others. To do so: 

At the “Pump Setup” screen (Figure 9) for the pump you want to copy from, touch Copy in 
the upper right corner. The Pump Copy screen appears, showing the pump number for the 
pump you are copying from.  

 

 

Follow the directions below to copy settings to one other station, a range of stations, or all 
stations: 

•  Copying to One Other Pump: 
1.  On the “Pump Copy” screen (Figure 10), touch the gray Copy to Pump button.  

The keypad pops up. 

2.  Enter the pump number for the station you are copying to. Use 

 (Backspace 

Key) to erase any mistakes.  Use 

 (Enter Key) to enter the value. The keypad 

disappears, and the “Pump Copy” screen shows the pump number you entered. 

3.  Touch the green Copy to Single Pump button. Complete briefly appears on the 

screen.