Sonance Visible and Dual Visible IR Emitter VE1 Leaflet

SONANCE • 212 Avenida Fabricante • San Clemente, CA 92672

Tech Support (800) 582-0772  www.sonance.com  

©2002 All rights reserved.

Pg 2

33-1379 4.02

120 V AC
(Unswitched)

IR Sensor
Window

Connecting Block

Power Supply

IR Receiver

Emitter

Dual Emitter

Dual Emitter

Satellite Receiver

Hand Held
Remote

AV Receiver

DVD

CONNECTING THE EMITTERS

• Simply insert the mono mini plug of the VE1 and VE2 emitters into the "EMITTERS" or

"OUT" jacks on any of the Sonance Connecting Blocks or Controllers.

• CAUTION: DO NOT plug emitters into the  IN/OUT or HIGH OUT jacks on the CB1 and

ACB1 Connecting Blocks. To do so will destroy the emitters!

• The following diagram illustrates a typical basic system using the VE1 and VE2 emitters.

• The VE2 is designed to control two devices. If only one is to be controlled, hide the extra

emitter behind the equipment. It may be used in the future if an extra device is added. 

• DO NOT CUT the extra emitter wire in an attempt to remove it. The two emitters are wired

in series. Cutting or removing one emitter will prevent the other from working. 

• These visible emitters may also indicate the presence of stray IR or RF interference by 

randomly blinking when no IR control signal is being sent. Reposition the IR receiver or the
interfering source to eliminate or reduce the random blinking. The more the random
blinking is reduced, the better the system will function.

• If the emitter glows red constantly, the signal line is shorted to “+12VDC”  or a constant 

noise, like florescent lights are present near the IR receiver.