Elk Products ELK-870 Leaflet
INSTALLATION for ELK-870
1.
Remove the front cover by inserting and twisting the tip of a wide flat-blade screwdriver in the slots along the edge of the housing.
2.
Mounting holes are provided on the backplate for a standard electrical J-box as well or for direct surface mounting (hardware included).
3.
Connect all wiring as follows. Recommended wire gauge is 22-24 AWG. If distance exceeds 1000' use 18-20 guage.
PWR IN:
Connect a good quality 12 to 24 Volt A.C. or D.C. power source. No polarity need be observed.
AUDIO IN:
Connect an audio input source. ie: microphone, radio, computer sound card, telephone PBX or KEY system paging output, etc.,
even an ordinary single line phone set (see diagram below). With Jumper JP1 set in the NO PREAMP position the ELK-870 is
setup for an audio signal of -15 dbm to + 10 dbm. This jumper may be placed in the PREAMP position to provide +18dbm addition
gain for weak audio input signals
even an ordinary single line phone set (see diagram below). With Jumper JP1 set in the NO PREAMP position the ELK-870 is
setup for an audio signal of -15 dbm to + 10 dbm. This jumper may be placed in the PREAMP position to provide +18dbm addition
gain for weak audio input signals
SPKR:
Internal speaker already connected. The ELK-870 speaker output can handle up to a maximum load of two (2) Ohms. Up to three
(3) additional 8 Ohm speakers (MIN = 20 Watt (ELK-70, ELK-14, ELK-1...) may be connected in parallel on these two terminals.
(3) additional 8 Ohm speakers (MIN = 20 Watt (ELK-70, ELK-14, ELK-1...) may be connected in parallel on these two terminals.
Recommended ELK-870 Spacing For Background Paging Applications
Ambient Sound Level
Location
Speaker Spacing
Quiet 50 to 65db
Offices
120 feet (14,400 sq. feet)
Moderate 65 to 80db
Light manufacturing
90 feet (8,100 sq. feet)
Noisy 80 to 90db
Heavy manufacturing
60 feet (3,600 sq. feet)
Very Noisy +90cb
40 feet (1,600 sq. feet)
VOLUME:
Turn the volume control clockwise (CW) to increase volume. Adjust to a comfortable level.
PREAMP:
If the audio input signal is too low for proper amplification, place Jumper JP1 into the PREAMP position for an additional audio
input gain of +18 dbm (8 X gain).
LIFETIME LIMITED WARRANTY
Elk Products, Inc. (“Manufacturer”) warrants to the original purchaser (the “Customer”) that the products it manufactures (“Product”) shall be free from defects in material and workmanship at time of shipment.
Manufacturer’s obligations under this Limited Warranty shall be limited to repairing or replacing, at its option, free of charge, any product returned to Manufacturer freight prepaid. Manufacturer shall have
no obligation under this Limited Warranty or otherwise if (1) the Product has been damaged by negligence, accident, mishandling, lightning or flood, or other Acts of God, (2) the Product has not been operated
in accordance with its operating instructions, (3) the Product has been altered or repaired by anyone outside Manufacturer’s authorized facilities (4) adaptations or accessories have been made or attached
to the Product which, in Manufacturer’s sole determination, have adversely affected its performance, safety or reliability. Products such as batteries and fused transformers have their own warranties, and
are not included in this Limited Warranty.
If a Product should malfunction or fail, contact Manufacturer or one of its authorized distributors for a Return Authorization (RA) number. Returned Products must include a complete description of the problem,
along with the RA number clearly marked on outside of the package. Manufacturer will not be responsible for any unnecessary items included with any returned Product.
THIS WARRANTY IS THE EXCLUSIVE WARRANTY FOR ANY PRODUCT. MANUFACTURER SPECIFICALLY DISCLAIMS ANY AND ALL OTHER WARRANTIES OF ANY KIND, EXPRESS OR IMPLIED,
INCLUDING ANY WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE OR OF MERCHANTABILITY. MANUFACTURER SHALL NOT BE LIABLE IN TORT, INCLUDING NEGLIGENCE OR STRICT
LIABILITY, AND SHALL HAVE NO LIABILITY AT ALL FOR INJURY TO PERSONS OR PROPERTY. MANUFACTURER’S LIABILITY FOR FAILURE TO FULFILL ITS OBLIGATION UNDER THIS LIMITED
WARRANTY OR ANY OTHER LIABILITY IN CONNECTION WITH A PRODUCT SHALL BE LIMITED TO THE AMOUNT OF THE PURCHASE PRICE RECEIVED BY MANUFACTURER FOR THE PRODUCT.
THE REMEDIES STATED IN THIS LIMITED WARRANTY ARE THE CUSTOMER’S EXCLUSIVE REMEDIES AGAINST MANUFACTURER REGARDING ANY PRODUCT. UNDER NO CIRCUMSTANCES
SHALL MANUFACTURER BE LIABLE FOR ANY INDIRECT, INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES, INCLUDING LOST PROFITS AND REVENUES, INCONVENIENCE OR
INTERRUPTIONS IN OPERATIONS, OR ANY OTHER COMMERCIAL OR ECONOMIC LOSSES OF ANY KIND. THESE LIMITATIONS AND DISCLAIMERS ARE NOT MADE BY MANUFACTURER WHERE
PROHIBITED BY LAW. SOME STATES PROHIBIT LIMITATIONS OF WARRANTIES AND THE CUSTOMER MAY HAVE ADDITIONAL RIGHTS IN THOSE STATES.
For more information contact your local Distributor or: ELK Products, Inc. - PO Box 100 - 3266 US Hwy. 70 West - Hildebran, NC, - 28637 - USA - 828-397-4200
Manufacturer’s obligations under this Limited Warranty shall be limited to repairing or replacing, at its option, free of charge, any product returned to Manufacturer freight prepaid. Manufacturer shall have
no obligation under this Limited Warranty or otherwise if (1) the Product has been damaged by negligence, accident, mishandling, lightning or flood, or other Acts of God, (2) the Product has not been operated
in accordance with its operating instructions, (3) the Product has been altered or repaired by anyone outside Manufacturer’s authorized facilities (4) adaptations or accessories have been made or attached
to the Product which, in Manufacturer’s sole determination, have adversely affected its performance, safety or reliability. Products such as batteries and fused transformers have their own warranties, and
are not included in this Limited Warranty.
If a Product should malfunction or fail, contact Manufacturer or one of its authorized distributors for a Return Authorization (RA) number. Returned Products must include a complete description of the problem,
along with the RA number clearly marked on outside of the package. Manufacturer will not be responsible for any unnecessary items included with any returned Product.
THIS WARRANTY IS THE EXCLUSIVE WARRANTY FOR ANY PRODUCT. MANUFACTURER SPECIFICALLY DISCLAIMS ANY AND ALL OTHER WARRANTIES OF ANY KIND, EXPRESS OR IMPLIED,
INCLUDING ANY WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE OR OF MERCHANTABILITY. MANUFACTURER SHALL NOT BE LIABLE IN TORT, INCLUDING NEGLIGENCE OR STRICT
LIABILITY, AND SHALL HAVE NO LIABILITY AT ALL FOR INJURY TO PERSONS OR PROPERTY. MANUFACTURER’S LIABILITY FOR FAILURE TO FULFILL ITS OBLIGATION UNDER THIS LIMITED
WARRANTY OR ANY OTHER LIABILITY IN CONNECTION WITH A PRODUCT SHALL BE LIMITED TO THE AMOUNT OF THE PURCHASE PRICE RECEIVED BY MANUFACTURER FOR THE PRODUCT.
THE REMEDIES STATED IN THIS LIMITED WARRANTY ARE THE CUSTOMER’S EXCLUSIVE REMEDIES AGAINST MANUFACTURER REGARDING ANY PRODUCT. UNDER NO CIRCUMSTANCES
SHALL MANUFACTURER BE LIABLE FOR ANY INDIRECT, INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES, INCLUDING LOST PROFITS AND REVENUES, INCONVENIENCE OR
INTERRUPTIONS IN OPERATIONS, OR ANY OTHER COMMERCIAL OR ECONOMIC LOSSES OF ANY KIND. THESE LIMITATIONS AND DISCLAIMERS ARE NOT MADE BY MANUFACTURER WHERE
PROHIBITED BY LAW. SOME STATES PROHIBIT LIMITATIONS OF WARRANTIES AND THE CUSTOMER MAY HAVE ADDITIONAL RIGHTS IN THOSE STATES.
For more information contact your local Distributor or: ELK Products, Inc. - PO Box 100 - 3266 US Hwy. 70 West - Hildebran, NC, - 28637 - USA - 828-397-4200
FIGURE 1: WIRING HOOKUP
OPTIONAL
Up to three (3) additional 8 Ohm
speakers may be connected in parallel
Min. rating = 20 watt
IE: ELK-70, ELK-14, ELK-1, ELK-44...
PRE
N
O
A
M
P PR
E
Built-In
20 Watt
Speaker
MI
N V
N V
O
LU
ME
ME
MA
X
ELK-870
Audio Amp
PC Board
12 to 24 Volts
AC or DC
No Polarity
Audio Source
Microphone, Radio, PC
Sound Card, Telephone
System Paging Output
S
P
K
R
JP1
12 to 24 Volts DC
ONLY
- +
P
W
R I
N
R I
N
AUDI
O
I
N
EXAMPLE 1: BASIC PUBLIC ADDRESS "PA" SYSTEM
(using the ELK-870 and a plain Telephone)
1,000 Ohm
1/2 Watt Resistor
P
W
R I
N
R I
N
AU
DI
O
O
IN
GREEN
RED
DO NOT CONNECT
TO TELCO LINES