Crimestopper Security Products SP-500 User Manual
6
OPERATING INSTRUCTIONS - ALARM
Arming / Locking:
Press the Lock Button on the remote control. The System will arm emit one siren chirp, one light flash, and the LED
will begin to flash. Power locks will lock (if equipped). Starter disable circuit will turn on. The 2-Way LCD Pager will
beep once while displaying a Locking symbol. After a short delay to allow the vehicle and electronics to settle, the
system will be completely armed.
will begin to flash. Power locks will lock (if equipped). Starter disable circuit will turn on. The 2-Way LCD Pager will
beep once while displaying a Locking symbol. After a short delay to allow the vehicle and electronics to settle, the
system will be completely armed.
Disarming: / Unlocking
Press the Unlock Button on the remote control. The System will disarm and confirm with two siren chirps, two light
flashes, and the LED will turn off. Power locks will unlock and Interior Dome light will turn on (if installed with these
optional features). The 2-Way LCD Pager will beep twice while displaying an Unlock symbol.
flashes, and the LED will turn off. Power locks will unlock and Interior Dome light will turn on (if installed with these
optional features). The 2-Way LCD Pager will beep twice while displaying an Unlock symbol.
Alarm Triggers:
If there is an intrusion into the vehicle, a hard impact to the body or the ignition is turned on, the alarm will sound and
flash the lights for 1 minute. After 1 minute, the trigger cycle will automatically stop and alarm will remain armed to
continue protecting the vehicle. If a door is left open after an intrusion then the unit will cycle a maximum of 2 minutes
and continue to protect the other un-tampered or unopened zones.
flash the lights for 1 minute. After 1 minute, the trigger cycle will automatically stop and alarm will remain armed to
continue protecting the vehicle. If a door is left open after an intrusion then the unit will cycle a maximum of 2 minutes
and continue to protect the other un-tampered or unopened zones.
LCD Remote Paging / Zone Violations:
When the system is triggered, the alarm sends a paging signal to the remote. If you are within range, you will receive
a paging signal that will light up the LCD Screen Red. The display will show an icon of what caused the violation. The
paging remote will also vibrate and
a paging signal that will light up the LCD Screen Red. The display will show an icon of what caused the violation. The
paging remote will also vibrate and
beep to notify
you the vehicle has been tampered with.
Disarming While Tripped (Triggered):
Disarming the System while it is triggering requires TWO presses of the Unlock Button. The first press Resets
the alarm cycle only (system still armed) while a second press will disarm/unlock the system.
Selective Silent Arming / Disarming:
To Arm or Disarm the system without siren chirps, press and release both the Unlock and Start Button at the
same time. The System will Arm or Disarm without siren chirps. Flashing lights and LED will be the only
indicators of Arm/Disarm status. The LCD will Display a musical note with an “Ø” when the system is armed or
disarmed without a chirp