Motorola Crib Toy MTM5400 User Manual
28
MTM5400 Mobile Terminal Installation Manual
INSTALLATION
DC Power Cable Installation
Installation Planning
The 3-meter (10-foot) DC power cable shipped with the terminal should be long enough to be
installed in most vehicles. Take the following precautions before you begin:
installed in most vehicles. Take the following precautions before you begin:
1.
Whenever possible, avoid routing the cable above the catalytic converter.
2.
Make sure that the power cable never rests on sharp edges.
3.
Use grommets whenever a cable has to pass through a hole in a metal panel.
The following table lists power cables available for this terminal:
In a vehicle with an airbag, make sure that the mounting
location of the mobile terminal, or of any terminal
accessory, is not in the deployment path of the air bag.
location of the mobile terminal, or of any terminal
accessory, is not in the deployment path of the air bag.
Uninstaling the radio
OPTION 1:
Before disconnecting the 13.2 V main power supply from
the radio:
the radio:
1. Switch off the radio.
2. Wait for a minimum of 4 seconds after the radio switch
is released.
is released.
3. Disconnect the 13.2 V main power supply.
OPTION 2:
Turn off the main power supply WITHOUT switching OFF
the radio.
the radio.
This terminal must be operated only in negative ground
electrical systems. Operating the terminal on a positive
ground system will cause the cable fuse to short-circuit.
Check the vehicle ground polarity before you begin the
installation.
electrical systems. Operating the terminal on a positive
ground system will cause the cable fuse to short-circuit.
Check the vehicle ground polarity before you begin the
installation.
Table 1 DC Power Cables
Number
Description
Rating
GKN6270
Power Cable to battery with fuse 10 A
12V Power Cable to Battery, Length: 3 m
GKN6274
Power Cable to battery with fuse 10 A
12V Power Cable to Battery, Length: 6 m
6500139767
Fuse 10 A for Power Cable
6580283E02 *
Fuse 4 A for Ignition Sense Cable