Jasco 24772 Instruction Manual

- Do not use in wet locations.

- Use indoors only.

- Turn power off before servicing -

  see instructions.

- Properly ground fixture.

- Ensure that no bare wires are exposed

  outside the electrical connections.

- Use within electrical rating of device

**This device is intended for use only with 

  GE Linkable products. Use of any other 

  lighting product may be hazardous.

1) Consult a local licensed electrician or

  electrical contractor if you are not sure

  about the installation.

2) Ensure that electricity is TURNED OFF at the

  main circuit breaker or fuse box. DO NOT

  ATTEMPT TO INSTALL ELECTRICAL BOX

  WITH THE POWER ON.

3) Select a suitable dry mounting location

  (for use indoors only). Make sure the

  mounting surface is capable of supporting

  the fixture.

4) Remove plastic cover from electrical

  mounting box by unscrewing the 2 screws.

5) Choose a suitable knock-out location from

  those provided on the box. Remove the

  knock-out with a screw driver. See Figure 1.

6) Place the electrical box in the location where

  it is to be mounted and mark the position of

  the mounting slots with a pencil.

7) It is recommended that a 1/16" pilot hole be

  drilled in the mounting surface.

8) Drive the screws provided in the mounting

  hardware into the mounting surface until the

  electrical box is secure.

9) Insert the threaded end of the strain relief

  (provided in the installation kit) into the selected

  knock out opening on the electrical box. Place

  the eyelet of the grounding (copper) wire provided

  in the installation kit around the strain relief. The

  grounding (copper) wire & eyelet should be

  located inside of the box. Secure the strain

  relief by tightening the lock nut. See Figure 1.

10) Install the conduit or armored cable to meet

  electrical codes. Tighten the two screws on

  the strain relief connector to secure the wires.

11) Connect the hot (black) AC supply wire(s) to

  the hot (black) wire in the electrical box.

  Secure the connection with the wire nuts

  provided. See Figure 1.

12) Connect the white (neutral) AC supply wire(s)

  to the neutral (white) wire in the electrical box.

  Secure the connection with the wire nuts

  provided. See Figure 1.

13) Connect the ground (green or copper) AC

  supply wire to the copper ground wire of the

  electrical box. Secure the connection with

  the wire nuts provided. If your electrical

  system contains no grounding wire, you

  should consult a qualified electrician before

  proceeding with the installation. See Figure 1.

14) Ensure that no bare wires are exposed after

  making the electrical connections.

15) Arrange the wires inside the fixture and

  reattach the plastic cover of the electrical

  box. Tighten the screws to ensure that all

  the wires and connections are sealed

  properly inside the fixture without "pinching"

  any wires.

UCF012-front

24772-2 rev11/18/05