Fortress Technologies ecure Wireless Access Bridge User Manual

Fortress Bridge: Fortress Security System Overview

115

The physical connections described in Section 7.1.2 are 
identified as logical interfaces, as defined by FIPS 140-2, in the 
table below:

An RJ-45-to-DB9 adapter (included with each Bridge) is 
required in order to connect the Bridge’s 

 port to a DB9 

terminal connection.

Figure 7.1 below shows the pin numbers for the two 
connectors. With the RJ-45 connector facing you and oriented 
with the tab receptacle up, pins are numbered from left to right, 
as shown. With the DB9 connector facing you and oriented with 

UL60950-1, IEC60529 (CB test), UL (NEMA) 3/3S/4 “raintight”

CE, FCC Class A

EN61000-3, EN61000-4

MIL-STD 810F 514 / SC-18 (pending)

nine RJ-45 10/100 Mbps Ethernet ports

two N-type antenna ports (female):

 radio configured as 802.11a/b/g tri-band port

 radio configured as high-gain 802.11a port (5.7–5.8 GHz

nine RJ-45 10/100 Mbps Ethernet ports

two N-type antenna ports (female):

 radio configured as 802.11a/b/g tri-band port

 radio configured as high-gain 802.11a port (5.7–5.8 GHz

nine RJ-45 10/100 Mbps Ethernet ports

one RJ-45 serial port

one 48V DC power input port

two N-type antenna ports (female):

 radio configured as 802.11a/b/g tri-band port

 radio configured as high-gain 802.11a port (5.7–5.8 GHz)

front-panel, recessed, warm-power reset control

nine RJ-45 10/100 Mbps Ethernet ports

one RJ-45 serial port

one 48V DC power input port

two N-type antenna ports (female):

 radio configured as 802.11a/b/g tri-band port

 radio configured as high-gain 802.11a port (5.7–5.8 GHz)

eight front-panel system LEDs

nine pairs integrated port link/activity & power LEDs

external +48V AC-to-DC adapter or 

WAN port power over Ethernet (PoE)