Avery ALS 206 User Manual
33
C
ONTENTS
3.2 I
NSERTING
LABEL
MATERIAL
ALS
20x
256
256
GB
3.2.2
Inserting a label roll
WARNING!
Risk of injury due to moving and rapidly
rotating parts!
rotating parts!
£
Before inserting the label roll, ensure that
the device is turned off at the main
switch.
the device is turned off at the main
switch.
£
Do not under any circumstances turn the
device on before the label strip is
threaded in completely.
device on before the label strip is
threaded in completely.
Removing spent backing paper
Assuming backing paper has gathered on the rewinder
[32A] :
[32A] :
£
Press the release button [32B].
– The tensioning mechanism of the rewinder is
slackened.
£
Remove the rewound backing paper.
Removing glue residue
£
If necessary, clean the following components:
– Dispensing plate
– Deflection rollers
– Drive rollers
– Pressure roller
– Deflection rollers
– Drive rollers
– Pressure roller
£
Follow the directions provided in section
“Maintenance and cleaning” on page 47.
“Maintenance and cleaning” on page 47.
Inserting a new label roll
£
Push the material roll [33A] onto the unwinder as far
as it will go.
as it will go.
£
Rotate the rotary knob [33B] in a clockwise direction
until the label roll sits tightly.
until the label roll sits tightly.
£
Run the label strip around the dancer arm as shown
in the figure [33C].
in the figure [33C].
[32] A Rewound backing paper
B Release button
C Backing paper path
C Backing paper path
B
A
[33] Inserting the material roll – Part 1.
A
C
B