Chicco KEYFIT 30 User Manual

Page of 21
20
21
Use.Newborn.Insert.to.provide.
additional.support.and.ensure.
a.secure.harness.fit.for.smaller.
infants.
To Install Insert in Carrier
1
.Pull End of Buckle.through.
center.slot.in.insert.
2
.Pull Both Harness Straps.
over.and.around.side.panels..Push.
insert.firmly.into.bottom.of.carrier..
3
.When properly installed, 
the.Newborn.Insert.and.harness.
should.look.like.drawing.
1
 ONLY USE Insert with infants who weigh between 4 and 11 
lbs.  NEVER USE Insert if child weighs more than 11 lbs!
2
3
NEWBORN INSERT
To Adjust Canopy, grab.bow.on.both.
sides.and.rotate...Detach.fastener.tabs.
when.rotating.toward.front.of.carrier.
a
.To Remove Canopy Fabric, pull.
fabric.away.from.Canopy.Mount.to.
expose.button..Press.button.on.canopy.
mount.to.release.end.of.bow...Slide.
canopy.fabric.off.bow.and.detach.
canopy.from.rear.of.pad..
To replace canopy, reverse.previous.
steps.
To extend/retract visor
b
.To.retract.the.visor,.gently.push.it.
downward.and.allow.it.to.pop.up.under.
the.canopy...The.canopy.must.be.
extended.before.attempting.to.retract.
the.visor...
c
.To.extend.the.visor,.gently.pull.
it.downward.from.underneath.the.
canopy.and.allow.it.to.pop.into.its.
extended.position.
CANOPY
a
 The harness height may 
have to be changed to fit your 
child. Before using insert, read 
the instructions on “Changing 
Harness Height” and “Securing 
Child in Carrier”
Top of insert should always be 
BELOW the lower harness slots.
b
c
 Release bow from canopy 
mount on opposite side of carrier 
if using carrier without canopy.