Allied Telesis 86253-07 User Manual

Patch 86253-07 for Software Release 2.5.3
C613-10382-00 REV E

A memory leak occurred if DNS relay was configured, and the device kept 
receiving DNS Query packets. This issue has been resolved.

PIM6 could not send unicast bootstrap messages to a new neighbour. This 
issue has been resolved.

If the SMTP Proxy detected a third party relay attack, the “

SMTP third 

party relay attack

” trigger message was not displayed. This issue has 

been resolved.

The forwarding database table sometimes did not update correctly when 
multiple packets with the same MAC source address were sent to the switch 
via different ports. This issue has been resolved.

The HWQUEUE parameter in the SET QOS HWQUEUE command 
incorrectly accepted values from 0 to 9999. The upper limit for this 
parameter is 3. This issue has been resolved. The correct limit is now 
enforced.

Two VRRP log messages were displayed when they should not have been. 
The log messages were:

Vrrp 1: Vlan vlan2 10 Port Failed decrementing priority by 20

Vrrp 1: Vlan vlan2 1 Port up incrementing priority by 2

This issue has been resolved. These messages are now displayed at the 
correct time.

OSPF neighbours did not establish the Full state when IP route filters were 
applied. This issue has been resolved.

The neighbour discovery timeout has been set to 3 seconds in ICMPv6 to 
speed up Destination Unreachable detection.

The badQuery and badRouterMsg counters in the SHOW IGMP and SHOW 
IGMPSNOOPING commands were not incrementing correctly. This issue 
has been resolved.

When an Inter-area route went down and the only other route to the 
destination was an AS-External route, the AS-External route was not 
selected. This issue has been resolved.